GW Instek GRG 450B Signal Generator

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode

GW Instek GRG 450B Signal Generator

Eric
Senior Member

Posts: 451
Threads: 85
Joined: Nov 2011
City: Cumming, GA

07-10-2023, 08:55 AM

I have this GRG 450B Sig Gen and it did not work so I opened it up and there are two burned up resistors R-508 & 510 both of these are in the RF Level push pull fine control. I can find a manual of operation but no parts list or schematic. I'm hoping someone has one and can open it up and read the resistors or give me the color code or a schematic.
Thanks

Eric
Eric

Find

« Next Oldest | Next Newest »

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
Philco 38-2 Automatic Tuning
I received my new 38-2 dial. I'm a little disappointed. As you can see in the picture the blues have a white shadow. The...dconant — 11:13 AM
Philco 38-2 Low Volume
I have been playing my 38-2 for a while now and it is doing very well. I did have to replace the 6A8 (osc) as it develop...dconant — 11:03 AM
Philco Speaker Spider
Hello, Does anyone with a 3 D printer make the spiders for those old Philco speakers? That might be a good idea for some...dconant — 09:41 AM
Philco 16B Parts
Hello, I'm looking to buy a 16B but I'm not so sure of what I am looking at. First as seen from the picture it looks lik...dconant — 09:17 AM
Looking for verification of correct schematic.
Klondike98, Thank you. I'll double check that SN and get back to you. GarySP, Thank you for the schematic.RossH — 12:13 AM
Looking for verification of correct schematic.
I think you have the correct take on your set. Ron's annotated early schematics that note the below B22000 serial numbe...klondike98 — 12:04 AM
Looking for verification of correct schematic.
Hello Ross. The Philco Radio Library located at the bottom of the page has the schematic with the tube count you have. ...GarySP — 10:48 PM
HiFi (Chifi) tube amp build - but my own design.
Tim It's be interesting if you put your schematic here. Who knows, you could get some advice from a few folks here. ...morzh — 10:01 PM
Philco 42-390, code 121 speaker
Thanks for that information. It would appear from the output transformer parts list that the transformer that was origi...Stevelog — 07:21 PM
Looking for verification of correct schematic.
I would like to verify that my thoughts are correct regarding my Model 70 and its appropriate schematic. My chassis inf...RossH — 06:26 PM

Who's Online

There are currently 985 online users. [Complete List]
» 1 Member(s) | 984 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me