Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Northern Electric 1121
#1

I am picking up this one next week.
 It has 11 tubes with push pull 6V6 tubes and a 5X4 for a rectifier.
Five bands, and a nice cabinet. It is called  the ''London''
 I already have the '' Bombay'' [last photo] which I have refinished.
  Just like a kid at Christmas I can't wait.
 Dan in Calgary


Attached Files Image(s)
               

   Living in Calgary Alberta
#2

Dan;
   It looks like they used a piece of TenTest/Donnaconda/Homasote board over the back of the speaker compartment, which is still available should anyone need some. 
Regards
Arran
#3

Nice find Dan,

I had a Vimy. I gave it to a friend. I don't know if it survived the divorce.

cheers
#4

Dan;
    Your Northern Electric "London" looks like it was the recipient of a strip n' clearcoat job, the dial also looks like you may have to get a replacement made at radiodaze. Those mid 30's N.E sets are notorious for their use of water based paint on their dials, lucky that Radiodaze can probably use a scan of the " Bombay" dial as a basis for the missing lettering.
Regards
Arran




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM
Hickok AC51 tube tester
Note that no power cord, power switch, or power transformer switch are shown. That (along with my experience with full s...DaleHCook — 07:09 AM

[-]
Who's Online
There are currently 5115 online users. [Complete List]
» 2 Member(s) | 5113 Guest(s)
AvatarAvatar

>