Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Not Your Average PHILCO
#1

Some years back I was given this 220v British A535 mfgr'd just after WW-II... It needed a little of everything but cabinet and chassis were in good condition... When I pulled chassis to restring dial cord I had a panic attack and not finding any info on web, put it back together... Well last year I searched again and the service info is now online, without it doubtful I'd have ever gotten dial cord strung properly... Now recapped & has two AC cords so I can operate it from both sides of a RCA ISOTap xformer... Still needs a bit of detailing and grille cloth is wrong...


Attached Files Image(s)
   
#2

That is a very cool little radio!!! How does she sound?
#3

I like those dials for sure.
Very nice little? radio? Or bigger lilt e tropic?

Icon_smile

Times I have been electrocuted in 2021
As of 1/01/2021
AC: 4 DC: 1
Last year: 6
#4

(04-08-2018, 04:22 PM)OldRestorer Wrote:  I like those dials for sure.
Very nice little? radio? Or bigger lilt e tropic?

Icon_smile

Not huge but at 15"W & 10"H, isn't small, largest Bakelite radio I own... Uses a 6" electromagnetic speaker that'd been replaced in early '60s, it and 5U4GB subbed for 5Y3G appeared to be only repairs... 

I had to rework P/S(added filter section)as the field coil has only around 25% resistance of orig(no idea on inductance)... Had a irritating low level hum that could not be subdued by juggling part values alone... Otherwise has it's original Brinmar 6K8G, 6K7G, 6Q7G & 6V6G shouldered tubes...  Rectifier is a NOS replacement Philco 5Y3G dated in 1951...

Supposedly it was onboard ship, so I don't imagine hum was noticable...


Attached Files Image(s)
   




Users browsing this thread:
[-]
Recent Posts
Rogers Majestic R-646
Vlad; I was just reminded of something else, I'm not sure why but many Rogers built sets do seem to have open primari...Arran — 04:40 PM
Rogers Majestic R-646
Thanks RpdB I don't think there's much difference with interstage transformers of different models other than dimersion...Vlad95 — 03:27 PM
Rogers Majestic R-646
Vlad; I looks like your set has the same problem that mine did, both a bad output transformer, and a bad audio inters...Arran — 03:21 PM
Rogers Majestic R-646
Ouch! Not often the secondary takes a hit. Wish there was a better solution. I have a good interstage transformer but it...RodB — 02:59 PM
Rogers Majestic R-646
By the way, the bypass you suggested is a rare solution in some circuits. For example, this schematics solution is used...Vlad95 — 01:43 PM
Rogers Majestic R-646
No, you are wrong, because you did not know the details. Unfortunately, only ONE winding out of six is intact in both t...Vlad95 — 01:14 PM
Rogers Majestic R-646
The output 45s are still in push-pull because the transformer secondary winding is still in the grid circuit providing o...RodB — 11:52 AM
Rogers Majestic R-646
Thanks RodB for the help. But this is not a real solution to this situation, not even a temporary one. Because the firs...Vlad95 — 11:34 AM
Philco Model 16 wiring question
I was going to check the voltages as you suggested and hooked it up to my dim bulb. It appears I have a short. The bul...bobclausen — 10:34 AM
Rogers Majestic R-646
You can bypass the interstage transformer by disconnecting the primary, connect a load resistor of about 10k - 20k to th...RodB — 09:40 AM

[-]
Who's Online
There are currently 999 online users. [Complete List]
» 2 Member(s) | 997 Guest(s)
AvatarAvatar

>