Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Zenith 8S-531
#1

Looking for a detailed layout of the underside of this radio.. Parts layout and wiring..

USES CHASSIS Number 8A02

Does anyone have or maybe worked on this and has some detailed drawings they made??

Thanks

Skip
#2

Anyone have a clue to what this is? and were the white wire goes??


[Image: https://live.staticflickr.com/65535/5026...b57f_c.jpg]

Skip
#3

Wherever the white wire is supposed to go it's a fairly late addition to the radio, probably because the original was a crumbling rubber wire.

Maybe that's the antenna coil?  It's hard to tell from that small view, can you post a picture of the entire underside of the chassis?

For anyone following the schematic is in volume 12, Zenith p. 12-18

.pdf Zenith 8-S-531.pdf Size: 936.66 KB  Downloads: 194

John KK4ZLF
Lexington, KY
"illegitimis non carborundum"
#4

First you need to figure out which coil it is (ant or osc). Then use an ohm meter to see what relationship the white wire has to the other terminals on the coil. Using the schematic sort out where the wire goes. Piece of cake!! Icon_twisted

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Restoring Philco 96
Morzh, Prayers for your mom. I am sure that there was enough pain living through the Holocaust as a child. I pray dail...MrFixr55 — 02:19 PM
Philco 610B oscillator wiring
Hi Dan, Divide and conquer. First off trry to differentiate between 60Hz and 120 Hz hum. 120 Hz hum has a higher pit...MrFixr55 — 01:49 PM
Restoring Philco 96
Yes, other than takin a toll on your back, they are undeed way more repair friendly than many other Philcos. To me, som...morzh — 01:04 PM
Philco 610B oscillator wiring
If the wires look like they were this way from the factory (very neat and very dull soldering joints), I'd leave them be...morzh — 12:58 PM
My Philco 37-116 Restore
I managed to open up the Expander Unit and replace the grid cap wires. Tested the connections found they looked good and...dconant — 12:19 PM
610B Oscillator Questions
I've included a picture of the 'actual' schematic I created. I double checked several times and it appears to be accur...Tubester — 09:26 AM
First Radio restoration
Hi, welcome. I did a 40-130 a few years ago. I was very surprised at how well it performed. Just take care with that sp...Stan the Man — 07:20 AM
Restoring Philco 96
Situations of the like are not pleasant. Life is inevitable. Best of luck to you. I have two 76 chassis, in different ...Stan the Man — 07:12 AM
Philco 610B oscillator wiring
Just picked up a Philco 610B a few months back to begin a new hobby of radio restoration. By way of introucition, I'm a ...Tubester — 06:11 AM
Philco 42-345 Restoration/Repair
Thanks Rodb looking at your picture of the cable I was able to reconnect the original cable just slightly shorter and ab...osanders0311 — 09:02 PM

[-]
Who's Online
There are currently 1802 online users. [Complete List]
» 1 Member(s) | 1801 Guest(s)
Avatar

>