Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Realistic Clarinette 40
#1

I said I would eventually make a separate topic about my recent 70's stereo phinds, so here is the first. This little guy has come a long way since I found it as a sawdust covered lump waiting for the trash man. The once forlorn looking Realistic has now become a nice little 'plastic wonder' of a 1978 stereo that really seems to like the Zenith Allegro 1000 speakers I have it currently paired up with. Still needs a few tweaks, but a final cleaning of the controls now has this unit almost perfect on balance and I can't really get it better without detaching the controls from the output board to get a direct shot into them. Not gonna do that and take a chance of killing the poor thing! The BSR record changer has come a good ways too. I might try some rubber renew on the idler first and also try to find a better 45 adapter. The one I have fits, but the changer doesn't seem to like it. Also, need a 'C' or 'E' clip for the platter. Right now I am listening to show tunes the local FM station is playing ranging from the late 40's to the early 60's.

   

Next up might be the 1972 Electrophonic once I get it out to be recapped. Found a nice set of Sears/Fisher speakers to pair up with it. Actually, even the Realistic gets along with those speakers as well.

No matter where you go, there you are.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Shadow Meter Bulb
Any 6.3 volt pilot light will work. I would use the brightest one I could find in my workroom. Be sure the dial is clean...RodB — 10:45 AM
HiFi (Chifi) tube amp build - but my own design.
Tim, nice write up and thanks for sharing !! Sincerely Richardradiorich — 02:47 AM
HiFi (Chifi) tube amp build - but my own design.
Well, this was a real "Hum-Dinger" :lol: ! This will be kinda long, but hopefully it will help others having t...TV MAN — 01:55 AM
Shadow Meter Bulb
Phorum members, I am trying to find the bulb # for PHILCO Shadow Meter part number 45-2180 that is from a 37-640 chassis...georgetownjohn — 06:53 PM
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM

[-]
Who's Online
There are currently 7845 online users. [Complete List]
» 3 Member(s) | 7842 Guest(s)
AvatarAvatarAvatar

>