Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

RCA R39
#1

I have a lead on a RCA R39. Looks to be  a Canadian built radio in reasonable condition. 8 tube TRF. Are these especially desireable?
#2

It's probably a "Victor" rather then an RCA is it was sold in the Canadian market. I believe that the R39 is one of the microsyncronous models, which debut for the 1929 model year, and were carried over until 1931, they have a funny arrangement with the tuning capacitors in order to allow them to be aligned to synchronize with the dial scale. The RF section is usually a series of #26 tubes as RF amplifiers, followed by a #27 detector, so not much different then an RCA Radiola 18 electrically, the audio amp and power supply is on the bottom chassis. In terms of value, well they are decent sets, not as good as a superhet, but with push pull #45s, electrodynamic speaker, and a heavy cabinet, they sound good. They are also fairly common, I think that Victor/RCA built something like 400,000 units over three years across all the models, so they are probably middle of the road in terms of value. At one time some guys had a scam of taking the power supply/amp chassis out, and pedaling them to Japanese audiophools as Western Electric amplifiers and speakers, so they used to be worth more because of that, until word got around the Orient that they were being swindled, now they are back down to where most late 1920s and early 30s consoles are. Be careful lifting these though, it's a two many job, the ones with a phonograph in top is a three man job.
Regards
Arran
#3

Thanks Arran!




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco Model 38-7: what caps & resistors do fail typically?
Yep the dim bulb test is OK but I'd definitely replace all those electrolytics before I did it. Since those #47 conden...klondike98 — 09:18 PM
Philco 42-345 Restoration/Repair
The resistor is a 2.2 Meg, it was the last one I hadn't replaced. The broadcast is coming in after replacing it.osanders0311 — 09:09 PM
Philco 42-345 Restoration/Repair
What does the resistor measure? I think it should be 3.3 Meg. If the oscillator coil has continuity and the resistanc...RodB — 09:03 PM
Philco Model 38-7: what caps & resistors do fail typically?
Good idea to check the coils... then I'll get hold of an incadescent light bulb and see what happens when the unit is sw...Musaeum — 08:49 PM
Philco 42-345 Restoration/Repair
I have that same set, ain't too much shortwave I like anyway.....it is a good AM DX set. PaulPaul Philco322 — 08:32 PM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum, Martin! Open a new thread in Philco Electronic Restoration when you begin working on your 38-7. ...GarySP — 08:28 PM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum! :wave: Here's the schematic for that radio from our digital library: Something to do bef...klondike98 — 08:05 PM
Philco Model 38-7: what caps & resistors do fail typically?
Hi all, on vacation in Montreal,  a friend of mine showed me a Philco Model 38-7 console radio from the 30ies. Mechan...Musaeum — 07:21 PM
Part numbers to model cross
I looked thru the documents and did not see one. Might have missed it though.Jim Dutridge — 07:16 PM
Philco 42-345 Restoration/Repair
Please tell me this was it, I replaced resistor 27 and it's playing on the broadcast band. I am afraid to change the ban...osanders0311 — 06:12 PM

[-]
Who's Online
There are currently 1073 online users. [Complete List]
» 2 Member(s) | 1071 Guest(s)
AvatarAvatar

>