Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Audel's Radioman's Guide
#1

I have noticed a lot of the new folks here who could use a good reference and learning book to guide them in their troubleshooting od antique radios. one does not need fancy modern equipment. A good signal generator is pretty much a must have to do alignments, but one can use an older one, I do. I just replaced the filter condenser. To make sure it is putting out the proper frequency, I use a modern digital readout shortwave receiver to cross check it. Fortunately, it is very close at the IF frequency area, so I don't need to do that to set the IFs. This is a great reference, and I recommend it to anybody who is serious about repairing the electronics in these old sets, Audel's Radioman's Guide. It is available on Amazon for a very reasonable price, even in hardbound. https://www.amazon.com/Radiomans-Constru...%27s+Guide
#2

Always wanted one so the price was right should be arriving Friday. Thanks Mike




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
1949 Motorola 5A9M
bob  Nice work on battery . If you don't. Have terminals i have a few spares  Samsam — 02:12 AM
1949 Motorola 5A9M
hello mr Fixr, for sure !! I have some radios that I need to make some batteries for too. Sincerely richardradiorich — 12:33 AM
1949 Motorola 5A9M
Dittos, sweet b on the battery. Love the "9 Lives" logo, remembered from my childhood. Other neat ones are t...MrFixr55 — 11:24 PM
Philco 46-1209 strange behavior
Hi Morzh, Dunno if the AC EMI caps are an issue. I never liked the concept but never had an issue with these causin...MrFixr55 — 11:21 PM
Philco 46-1209 strange behavior
And no hum without the 7AF7? Not common but I am thinking heater - cathode short. This would introduce hum in this sta...MrFixr55 — 11:14 PM
schematics
Those filter caps in the cardboard tube are easy to restuff, especially the kind with the rolled over end. You don't hav...Arran — 09:56 PM
Philco Model 16 wiring question
If you have 5 wires, do this: The wires that go to thick-wire wound winding are the filament. If you do not know wha...morzh — 09:03 PM
Philco Model 16 wiring question
I recently acquired a Philco Model 16 Code 126. I removed the power transformer to place heat shrink on some very bad...bobclausen — 08:23 PM
1949 Motorola 5A9M
Hello Bob, That battery looks great nice job ! Sincerely Richardradiorich — 08:20 PM
1949 Motorola 5A9M
Yes, I plan to put a Velcro closer on the top.klondike98 — 07:28 PM

[-]
Who's Online
There are currently no members online.

>