Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

38-690 puzzle
#1

I am starting to work on my 38-690, but right now just studying the schematics to get the overall flavor of the circuits. One oddity jumps out. There is a 6J5 labeled as Bass-Amp AVC, near the audio driver and output circuitry.

My diagram (from Chuck) shows the plate is tied directly to the cathode and ground. Is this tube doing anything? It looks like a dummy inserted to up the tube count! Or am I missing something subtle?? I haven't actually looked at the chassis yet to see if that is how it is wired.

Bill
#2

This tube is connected as a diode; with the grid acting as a diode "plate".

Very interesting circuit. It is used to control the gain of the bass amp tube (6K7G) in much the same manner as AVC is normally used to control gain of RF and IF tubes, and sometimes mixers as well. A portion of the audio signal is taken from the plate of the audio driver tube (6F6G) and fed to the grid of the bass amp AVC tube, where it is rectified and sent on to the suppressor grid of the bass amp tube. This serves to control the amount of signal amplified by the bass amp tube.

Yes...very interesting indeed.

--
Ron Ramirez
Ferdinand IN
#3

I see, I see! Weird but neat...




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 91 Speaker Replacement
The spider is glued on the cone and so is the voice coil. I think you can use a cotton swab dipped in acetone and carefu...RodB — 02:42 PM
Restoring Philco 37-604C
Yes I saw that. If I knew, I'd probably try to arrange for getting it myself. But I have just got one. Which does not m...morzh — 01:44 PM
Philco 38-2 Automatic Tuning
When you push the lever, you are supposed to rotate the disk to the desired station. Then the magnetic tuning will acqu...morzh — 01:42 PM
Philco 38-2 Automatic Tuning
I figure out the muting from another picture that helped. Now I need to know how the automatic tuning works. When I push...dconant — 12:11 PM
Philco 91 Speaker Replacement
How would I go about removing the spider from the cone?dconant — 12:04 PM
Philco 38-2 Automatic Tuning
Hello, I am having trouble getting my automatic tuning to stay unmuted. If I play with the tuning handle I can get it to...dconant — 10:51 AM
Does anyone make photofinish replacements?
Here’s the link to the DIY photofinish section of our site: klondike98 — 09:46 AM
Delco car radio Peko vibrator converstion issues
Hi Richard, Thx for posting the schematic.  As I remember as a kid, these were great performers for the time, likely...MrFixr55 — 08:56 AM
Delco car radio Peko vibrator converstion issues
hello mr Fixr, The Electro  Powersupply that I am powering the radio with has a huge choke plus a 10,000ufd electrolyti...radiorich — 10:58 PM
Delco car radio Peko vibrator converstion issues
How about putting a choke in the power supply? The big cap was likely an attempt to stabilize the DC. Kids who cre...MrFixr55 — 09:19 PM

[-]
Who's Online
There are currently 2824 online users. [Complete List]
» 2 Member(s) | 2822 Guest(s)
AvatarAvatar

>