Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Model 70 field coil resistance
#1

Hi
Does anyone know what the field coil resistance is for a model 70/570 chassis with 1, 47 tube ?  My field coil opened, and am trying to find a replacement speaker 
Thx
Bruce
#2

Hello, 3100 ohms
Here is a link for some information.
https://philcoradio.com/library/index.ph...-21-70-90/
#3

Thx
That gives me what I need ?
#4

???

It is 3100 ohms. This is what you asked, this is what Mike said.
The replacement is any K-type speaker, they all have the same Field coil and voice coil.
You need any Single ended transformer type, from 70 or 90.
The 20 will also work. But I don't think it should be used, though with the transformer changed it is the same speaker.
I just did exactly that, my 570 had a 20 speaker with bad xfmr, and I had a spare xfmr from a 70.

People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently 2939 online users. [Complete List]
» 1 Member(s) | 2938 Guest(s)
Avatar

>