Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Zenith 6-S-843BT Schematic?
#1

Hi - Does anybody know where I might find a schematic for this radio? It a Zenith 6-S-843BT export model. Searching only turned up a couple of Spanish and Portuguese magazine ads and a couple of old Ebay auctions, no schematics. Rider's doesn't have it. I want to say the cabinet was stamped 1948, but I'm too lazy to go to the basement to check  Icon_biggrin .

I just started to refinish the cabinet and would like to align it before I put it back together. I could probably figure it out on my own, but would rather have a schematic if one exists.

Greg

   

   

Can't think of anything witty.
Greg O.
Whitehall, PA
#2

Your set has a duel voltage power transformer so maybe that is the only difference!!!! Found this kinda maybe it will work. Stay safe David       http://www.nostalgiaair.org/Resources/245/M0025245.htm




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently no members online.

>