|
38-2 socket voltages question
02-13-2021, 09:17 PM
Hi, Im going through a 38-2 and have checked socket voltages. I attached a photo of my readings. Most are pretty close and i have a few which are somewhat off: the 6j5, 6n7 and the electrolytics which are new. I have recapped, and resistors where needed.
In general what am I looking for? is +-20% acceptable? thanks 
02-13-2021, 09:34 PM
I'd have a look @ the 190v line seems low @ 164v.
When my pals were reading comic books I was down in the basement in my dad's workshop. Perusing his Sam's Photofoacts Vol 1-50 admiring the old set and trying to figure out what all those squiggly meant. Circa 1966 Now I think I've got! Terry
02-13-2021, 10:47 PM
In. All of them. For instants if you removed the 5X4 you would have no high voltage at all.
When my pals were reading comic books I was down in the basement in my dad's workshop. Perusing his Sam's Photofoacts Vol 1-50 admiring the old set and trying to figure out what all those squiggly meant. Circa 1966 Now I think I've got! Terry
02-14-2021, 10:13 AM
alright all those measurements were with tubes in place. Im going to put it on the bench again today and ohm out some more resistors
02-14-2021, 11:40 AM
Not only with tubes in place but with the speaker in too.
People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.
« Next Oldest | Next Newest »
Users browsing this thread: 1 Guest(s) |
|
|
![[-]](https://philcoradio.com/phorum/images/bootbb/collapse.png "[-]")
