Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 650 Chairside Radio
#1

I just acquired a Philco model 650 Chairside radio. Eight ( 8 ) tubes , original knobs (Yea!) and cabinet intact. I cannot locate ANY data on this radio. I also find the radio interesting as it had no grille cloths ... the outlet grills on all sides were backed by "baffle boards" ca. 1/4 inch from the inside cabinet. Unfortunately, the original speaker(s) were replaced by more moden permanent magnet type speaker.

Any and all information on this interesting radio will be greatly appreciated.

Regards, all,

Frank
#2

Hi

Great acquisition! I had one of those a few years ago...wish I had kept it.

I have some info on the 650RX here:
http://www.philcoradio.com/gallery/1936a.htm#an

I seem to recall that the separate speaker cabinet originally used a permanent magnet speaker, and it used a choke instead of a field coil.

--
Ron Ramirez
Ferdinand IN




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Made mistake & did not label connection
Hi John, I don't have this radio, but I can supply some info: Based on your pic, pins 7,8 and 1 are used together...MrFixr55 — 02:02 PM
New Philco Repair Bench
As far as I know, the Repairbench does not work, and has not been working in a while. Chuck (we had that campaign looki...morzh — 01:33 PM
Radio city products 664 schematic request
Need a schematic or manual for the 664. The 663 may be similar.daveone23 — 12:38 PM
New Philco Repair Bench
Thanks Gary.dconant — 12:16 PM
New Philco Repair Bench
I tried accessing the site through our library and got the same response. It's reported to our tech gurus. GaryGarySP — 11:50 AM
New Philco Repair Bench
I am sure this is the archive, and not the Chuck's site.morzh — 09:50 PM
Made mistake & did not label connection
It's not like we are good friends with that wire and can tell it from other ptetty identical looking wires. Why'n't you...morzh — 09:49 PM
Made mistake & did not label connection
I'm not sure why that wire wasn't covered in the video. I'm pretty sure the 6A8 won't work until that pin is grounded. Y...RodB — 09:47 PM
Made mistake & did not label connection
You'll have to forgive me, I am not sure what you mean.  Can you explain what you are really saying.  If anyone does not...georgetownjohn — 08:05 PM
Made mistake & did not label connection
Those are details better left to the ones who know. Maybe you disconnected the wrong end of the wire.RodB — 06:22 PM

[-]
Who's Online
There are currently 5975 online users. [Complete List]
» 2 Member(s) | 5973 Guest(s)
AvatarAvatar

>