Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Asking for help with Philco Ford Mini Phono/Radio Model S-1379GR
#1

Hi everyone,
I recently lucked into finding a pretty cool Philco Ford Miniature Radio/Phonograph at a Salvation Army. I took it home, popped in some C batteries and the radio seems to work excellently, playing out of the speaker. The phono motor works and seems to run at proper speeds, but no sound is coming out of the speaker. Seems odd because the speaker clearly works with the radio. I’m wondering if the needle cartridge might need replacing or if there may be a lose wire from the phono arm?

In any case, I know this forum is mainly for older  Philco radios and tvs but I was just wondering if anyone had any experience with this device.  Maybe an old manual or just happen to know if there’s a replacement needle cartridge that will work.

Thanks for any help you can give!
#2

Welcome to the Phorum! Start with the cheap and easy stuff. Clean the selector switch contacts and check for possible loose wires. Would not be an unusual instance for the cartridge to be needing replacement, but start with basic 'once-over' simple options first. You just might get lucky. Take care and BE HEALTHY! Gary

"Don't pity the dead, pity the living, above all, those living without love."
Professor Albus Dumbledore
Gary - Westland Michigan




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
462ron
Hi Dan, your original dial appears to be lighter, easier to allow light through. My original is similar except it’s crac...462ron — 12:07 PM
Philco 38-2 Automatic Tuning
I received my new 38-2 dial. I'm a little disappointed. As you can see in the picture the blues have a white shadow. The...dconant — 11:13 AM
Philco 38-2 Low Volume
I have been playing my 38-2 for a while now and it is doing very well. I did have to replace the 6A8 (osc) as it develop...dconant — 11:03 AM
Philco Speaker Spider
Hello, Does anyone with a 3 D printer make the spiders for those old Philco speakers? That might be a good idea for some...dconant — 09:41 AM
Philco 16B Parts
Hello, I'm looking to buy a 16B but I'm not so sure of what I am looking at. First as seen from the picture it looks lik...dconant — 09:17 AM
Looking for verification of correct schematic.
Klondike98, Thank you. I'll double check that SN and get back to you. GarySP, Thank you for the schematic.RossH — 12:13 AM
Looking for verification of correct schematic.
I think you have the correct take on your set. Ron's annotated early schematics that note the below B22000 serial numbe...klondike98 — 12:04 AM
Looking for verification of correct schematic.
Hello Ross. The Philco Radio Library located at the bottom of the page has the schematic with the tube count you have. ...GarySP — 10:48 PM
HiFi (Chifi) tube amp build - but my own design.
Tim It's be interesting if you put your schematic here. Who knows, you could get some advice from a few folks here. ...morzh — 10:01 PM
Philco 42-390, code 121 speaker
Thanks for that information. It would appear from the output transformer parts list that the transformer that was origi...Stevelog — 07:21 PM

[-]
Who's Online
There are currently 1322 online users. [Complete List]
» 4 Member(s) | 1318 Guest(s)
AvatarAvatarAvatarAvatar

>