Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

My Philco 41-280 story.
#1

Came across this forum yesterday and thought I’d make a post.

My dad bought this Philco 1941 41-280 back in 1961 at the age of 12 from a used furniture store for only $5, located in Richmond CA (SFO Bay Area). In 1996 at the age of 14, I started listening to Short Wave on it.  At that time Dad and I pulled the Chassis and did a good cleaning.  Checked all the wires and connections.  It has 6 Philco tubes, which I assume are original.  The other 2 tubes are a different brand and were installed before 1961, when dad bought it.  The “cat gut” string used to move the needle when tuning had a few spots that were starting to fray, so dad and I went to a TV / Radio repair shop (remember those?) and robbed the cat gut string out of a couple of home stereo radios.  Replaced the cat gut string.  I also removed the speaker and grill.  Cleaned the grill, found a good quality spray paint that was a close match to the original color of the speaker grill and gave it a repaint.  The 12” speaker has a 2 - 2.5” hair line crack in the cone, but does not effect the audio sound.

I listened to short wave almost every night for 3 - 4 hours on this 41-280 from Spring of ‘96 to Christmas of ‘97 when I got a radio shack DX-375 portable Short Wave radio, which I still use today when traveling.

If it was not for my 1941 Philco 41-280, I never would have gotten my Ham Radio licenses December ‘99 at the age of 17. KD5ITM

Right now the Philco is in my home office.  And yes, it still gets used a few times a month.        


Attached Files Image(s)
           
#2

Welcome to the Phorum!
Icon_wave

Great story!
#3

Welcome to the Phorum! Your last comment was that you listen to the console a few times a month ... Has the chassis been rebuilt? If not I would not play it until you do so. All capacitors and any out of tolerance resistors should be replaced, and special attention given to the condition of the rubber wiring. All of these could ruin your day if they fail.
I have a 41-280x that I bought years ago at an estate sale. The trim on the sides of the speaker on mine had been stripped of its' photo finish. The previous owner did a very good job of matching the new finish to the existing cabinet finish, and I left it that way.
Take care and BE HEALTHY! Gary

"Don't pity the dead, pity the living, above all, those living without love."
Professor Albus Dumbledore
Gary - Westland Michigan




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM
Model 28L
Hello, I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020. Can...HORSTE — 10:32 AM

[-]
Who's Online
There are currently 6054 online users. [Complete List]
» 2 Member(s) | 6052 Guest(s)
AvatarAvatar

>