Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

37-116 Mag Tuning question
#1

I've had one for close to 30yrs now that I got at an auction for $35. When I got it I replaced all the caps and such and it work great. About 10yrs ago it died and I'm thinking about putting her up on the bench and seeing what the matter is. I have a simple question. Does the mag tuning operate on the BC band only or will it act as an afc circuit on SW?
Tnx
Terry
Going the pickup a 37-675 tomorrow!! Tnx to Pete in NJ

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#2

Hi Terry,

I restored a 37-675 (non tele-dial version) a few years ago. I believe that the 675 and 116 use the same sub-chassis. I thought that the magnetic tuning was used on all bands on the 675 and the schematic for the 116 confirms that. I was very pleased with the performance of the 675. If I had not bought a 16X I would have kept the 675. That sub chassis was a major pain to work on.

Sean
WØKPX
#3

7estatdef Wrote:I've had one for close to 30yrs now that I got at an auction for $35. When I got it I replaced all the caps and such and it work great. About 10yrs ago it died and I'm thinking about putting her up on the bench and seeing what the matter is. I have a simple question. Does the mag tuning operate on the BC band only or will it act as an afc circuit on SW?
Tnx
Terry
Going the pickup a 37-675 tomorrow!! Tnx to Pete in NJ

Works on all bands. See the Magnetic Tuning info from my site:

PHILCO SERVICE HINTS & TIPS - NUMBER 33
Aligning the Magnetic Tuning System
http://www.philcorepairbench.com/tips/svctip33.htm

Chuck




Users browsing this thread:
[-]
Recent Posts
Testing a speaker and output transformer Trutone A2-G
Well I have found 315v on the rectifier when cold. Drops off to 280 after 15 minute warmup. Checked pin 3 on both 6F6 t...murf — 04:14 PM
Testing a speaker and output transformer Trutone A2-G
Thanks for the replies, I will check these ideas out and report back. murfmurf — 03:18 PM
Testing a speaker and output transformer Trutone A2-G
Sorry, my mistake. murfmurf — 03:07 PM
Testing a speaker and output transformer Trutone A2-G
MrFixr Honestly, I haven't done that yet and do not want to screw up the threads; maybe you could do it, or we could...morzh — 12:48 PM
Two small radios from France. Restoration and review.
Greetings; I think that it's possible that the assortment of components was the result of post war parts shortages, a...Arran — 12:18 PM
Philco model 38 code 121 not receiving signal.
Unfortunately I can't inject any audio into the volume control. It is in the primary circuit of the antenna coil, not in...Stormlord5500 — 09:32 AM
Philco model 38 code 121 not receiving signal.
Sounds good Gary I'll do that. I have plenty of stuff like that I can scrounge up. I am still kind of new to all this so...Stormlord5500 — 08:47 AM
Philco Battery-WWII vintage
Seems to me that this a general purpose or radio filament 6V battery of very high amp-hour capacity and very high "...MrFixr55 — 08:08 AM
Testing a speaker and output transformer Trutone A2-G
Hi Morzh, From my end, no. I did not know that there are 2 threads on this topic. Maybe it should be combined.MrFixr55 — 07:13 AM
Testing a speaker and output transformer Trutone A2-G
Any reason for the 2nd copy of the thread?morzh — 10:22 PM

[-]
Who's Online
There are currently 275 online users. [Complete List]
» 2 Member(s) | 273 Guest(s)
AvatarAvatar

>