Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Can anyone tell me about this console stereo?
#1

I brought this console back from my mother's house in PA. If I remember, it sat inside our front door at the house I was raised in. We moved into that house in 1962, but that's as close as I can get. I don't remember if it was bought when we moved in or it came later. The model number on the back is P 1744-124. Any ideas on a truer date, worth, etc? It is complete and still works. Has buttons for PHONO, TAPE, AM and FM. Thanx very much!

Note from site admin: Sorry, but the photo which was attached to this post is no longer available.
#2

Can't tell you much about it as it is way to new for us. Was made about 1967 from what I can tell but here at the Phorum we deal with Philco's that are pre 1950 or so.
Sorry
Terry

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#3

With the suffix P in the model number, that would make it a Model Year 1966, hitting the dealers about fourth quarter 1965 for the 1966 buying season.

Chuck
#4

What kind of tape did it take, just out of curiosity? Reels or 8-track? I suspect 1966 would've been way too early for cassette...




Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
Shadow Meter Bulb
Phorum members, I am trying to find the bulb # for PHILCO Shadow Meter part number 45-2180 that is from a 37-640 chassis...georgetownjohn — 06:53 PM
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM

[-]
Who's Online
There are currently no members online.

>