Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Help identifying a Philco Radio/Turntable
#1

Hi,

Apologies if this is going to the wrong section of the forum. I have just acquired a Philco radio/Turntable cabinet (my Dad would have called this a radiogram but I don't know if this is correct). The radio works fine and the turntable spins also. I only paid £20 for it so I wasn't overly concerned that the chap who sold it to me said that when a record is put on the turntable the pick up arm just skates across it. It would be nice to know what kind of stylus I need to fix it though. The unit looks to be 1950s /1960s in style and is about 3 feet long and maybe 14 inches deep and 18 inches high. It is basicalle a cabinet with a polished wooden top - all the controls etc. are on the front. It has a horizontally opening tambour door to the left containing a turntable behind. The turntable is four speed and has a Monarch badge on the front of it. The radio has four control knobs silver on the front and about one and a half inches in diameter. The radio section has a cream fabric type speaker grill above it. The cabinet has Model 5400 printed on the back but googling this has not thrown up a picture that matches what I have. Hence my post. I tried to upload pics but the file sizes are too big. I would welcome any information anyone can give me.
#2

Hello and welcome!

I'm assuming your Philco find was made in the UK? If so, I'm afraid no one on this side of "the pond" has any information on British Philco sets. Sorry about that. Most Philco (UK) sets are very different from USA Philcos.

--
Ron Ramirez
Ferdinand IN




Users browsing this thread:
[-]
Recent Posts
Zenith H725
Ed; One thing that I will say about these is that Brand Z was considerate enough to make these mica caps easily acces...Arran — 02:34 PM
Philco 610B oscillator wiring
Do you know what run # your chassis is? It took me a while to find what you were basing updates/modification on as I did...Radioroslyn — 07:34 AM
Need to purchase some accessories for restoration of my Old Philco Radio
COLLEAGUES, Thank you all for such good and important suggestions as how to find good replacement parts. I will go fo...palonso — 07:05 AM
Zenith H725
Here's what the inside of AM IFT2 looked like, and the other pic shows the discs I made to take place of the mica and ke...EdHolland — 07:40 PM
Zenith H725
IF2 will need replacement caps. The arcing was severe enough that the mica is pitted and holed where the HT flashed over...EdHolland — 04:04 PM
My Philco 37-116 Restore
Measuring from center tap like the tube voltages show. Cap 127 is isolated from ground. Cap 127 shown in upper left of p...dconant — 08:05 AM
My Philco 37-116 Restore
Are you measuring relative to the centertap or the GND?morzh — 11:57 PM
Philco 610B oscillator wiring
Still not clear on the wiring interface between the 6A7 and oscillator. After refering to the available schematics and s...Tubester — 07:18 PM
Refinishing Ideas
My 37-116 code 121 is the best sounding radio i have...a daily driver. Since we are talking about "changes". ...poulsbobill — 07:18 PM
My Philco 37-116 Restore
Hello, I finally got brave enough to take the cans off the Expander Unit. Got the grid cap wires replaced and back toget...dconant — 06:50 PM

[-]
Who's Online
There are currently 514 online users. [Complete List]
» 4 Member(s) | 510 Guest(s)
AvatarAvatarAvatarAvatar

>