Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Silvertone 1671 schematic/labels
#1

I am restoring a Silvertone 1671 table radio and no matter where I search, free or for cost, I cannot find schematic/alignment info for this set. The closest I came is model 1571/1171, chassis 101.610-1. My chassis is 101-610 but there are definite differences.

This set uses a voltage doubler AC rectification scheme that appears a bit different from the 1571, as well as the tone control being a switch in the 1571 vs. a pot in the 1671. Does anyone have a schematic or know where I can obtain one?

Also the three labels on the back of the chassis are virtually disintegrated and wonder if anyone who has a similar set could take some clear photos so I can try to reproduce them. One is a vertical label on the IF can and the other two are on the right side of the rear panel.

Thanks,

Steve D

http://demandred.dyndns.org/540i/gallery/Antique-Radios




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently no members online.

>