Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 37-670 problem finally solved
#1

My 37-670 would play well for a few minutes and then lose volume to the point that you could not hear the station at all. Simultaneously the shadowmeter went completely black. I put off working on it, mainly because it is large, heavy, and a pain in the (thing one sits on) to lug off the relatively high place it occupies, transport to my work table, and take apart. Today I stopped putting it off and gave myself a healthy dose of pain in my (thing I siit on) getting it to my work table and apart.

Long story short: problem was a 6K7G tube (IF amplifier) that tests good on my tester when "cold" but tests bad when "hot."

First time I have had a tube issue like this.

The radio played for over an hour after replacing the 6K7G, so believe problem solved.

Color me pleased and (thing I sit on) sore.
#2

Before you toss that 6K7, try resoldering the pins on the base as well as the grid cap, particularly the cathode pin, I found a 6K6 tube like that lately, tube lit up but no reading.
Regards
Arran
#3

Great advice! I'll do that.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Rogers Majestic R-646
By the way, the bypass you suggested is a rare solution in some circuits. For example, this schematics solution is used...Vlad95 — 01:43 PM
Rogers Majestic R-646
No, you are wrong, because you did not know the details. Unfortunately, only ONE winding out of six is intact in both t...Vlad95 — 01:14 PM
Rogers Majestic R-646
The output 45s are still in push-pull because the transformer secondary winding is still in the grid circuit providing o...RodB — 11:52 AM
Rogers Majestic R-646
Thanks RodB for the help. But this is not a real solution to this situation, not even a temporary one. Because the firs...Vlad95 — 11:34 AM
Philco Model 16 wiring question
I was going to check the voltages as you suggested and hooked it up to my dim bulb. It appears I have a short. The bul...bobclausen — 10:34 AM
Rogers Majestic R-646
You can bypass the interstage transformer by disconnecting the primary, connect a load resistor of about 10k - 20k to th...RodB — 09:40 AM
HiFi (Chifi) tube amp build - but my own design.
So, here's Prince on stage halfway through Purple Rain when he stoops down to his tech and says "Rod, pull out that...RodB — 09:17 AM
Rogers Majestic R-646
Today I finished inspecting all the parts. The result is not very pleasing. The first positive news: 1) The power tr...Vlad95 — 11:40 PM
HiFi (Chifi) tube amp build - but my own design.
Well, found muh culprit. After using socket test adapters and finding voltages all ok, swapping 6V6s, no avail, swapped ...TV MAN — 11:18 PM
HiFi (Chifi) tube amp build - but my own design.
Well, maybe - maybe not  :lol: It's been an interesting project so far! Something so simple, yet so cranky. The 1st one ...TV MAN — 05:12 PM

[-]
Who's Online
There are currently 966 online users. [Complete List]
» 1 Member(s) | 965 Guest(s)
Avatar

>