Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Never say never
#1

Been looking for a PP 45 Philco 90 chassis for awhile now. Couple of weeks ago saw an ad in Craigslist for two very rough consoles, 20.00 each. One looked like it might be a 90, so what the heck, I went to check it out.
Yep.... a model 90 with the PP 45s and a speaker to boot. Has all of it's tubes, including one blue arcturus globe 27. Also has both copper mershons. Twenty dollars well spent.
#2

CONGRATS!!!!!
Seek and yea shall find!
Terry
#3

Nice find! Deals like that don't come up to often!

-Keith
#4

Thanks, guys. Also found a Philco 111 in SC on the same trip, but bad news is that it was the week after I was released from hospital for Pneumonia, and my rash of activity caused a (unprintable) relapse!

Photos will follow soon, right now am trying to anticipate my visiting nurse' routine so that she doesn't suprise me doing somthing I'm not supposed to be doing. Icon_wink





Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently no members online.

>