Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Hi all here is my latest toy
#1

I found this little tumbstone and could not resist. Icon_smile The cabinet needed a lot of glue and repair Icon_sad but I think it come out o k. As you can see from the pictures it was in bad shape. It is the first Crosley I have ever messed with, notice the caps were dual, two in one paper tube with the common comming out at the mounting ring and soldered to the ring. Icon_think I had never seen this set up. Anyway here is the pictures
here is how I got it
[Image: http://i927.photobucket.com/albums/ad118...C03634.jpg]
[Image: http://i927.photobucket.com/albums/ad118...C03634.jpg]
Here is the dual caps
[Image: http://i927.photobucket.com/albums/ad118...C03632.jpg]
and what I ended up with
[Image: http://i927.photobucket.com/albums/ad118...C03638.jpg]

Joe

Joe Bratcher near Louisville, KY
#2

Joe

It looks nice.
Is it playing yet?
#3

Hi
Yes it plays very good, it has no AVC, so tuning is tricky but after tuned in it works fine . The volume control is at the antenna input. I just could not pass it up. Joe

Joe Bratcher near Louisville, KY
#4

Nice little Crosley! Yes, Crosleys can be good performers once you get them going. But, since Crosley radios were built with an eye towards low cost, you can run into many headaches in them as well. Still, I love the art-deco Crosley tombstone I've got. Think I will get it out after work and enjoy it some this evening. Icon_smile

No matter where you go, there you are.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently 3266 online users. [Complete List]
» 1 Member(s) | 3265 Guest(s)
Avatar

>