1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Threaded Mode
Philco 90 speaker replacement
tab10672
Senior Member
****
Posts: 411
Threads: 42
Joined: Sep 2008
City: Ironton Ohio
#1

04-09-2012, 04:56 PM
A friend of mine needs a speaker for his single 47 model 90, I have a spare model 20 with dual 71's according to a chart I found the plate load for a single 47 is 7000, 2-71's is 8000. With 1000 ohms higher impedance on the pri. of the transformer will this speaker work ok or will the load differance effect sound quality or tube current to the point of failure?

Thanks, Todd
(This post was last modified: 04-09-2012, 04:59 PM by tab10672.)
Find
« Next Oldest | Next Newest »
Thread Closed




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Can anyone help me figure out a capacitor that has 3 wires coming out of it red and green on one side and a black wire o...osanders0311 — 08:14 PM
Testing a speaker and output transformer Trutone A2-G
The transformer may be the last cause of voltage drop. This level of voltage drop is not too big. Conduct additional te...Vlad95 — 07:16 PM
Testing a speaker and output transformer Trutone A2-G
Well I have found 315v on the rectifier when cold. Drops off to 280 after 15 minute warmup. Checked pin 3 on both 6F6 t...murf — 04:14 PM
Testing a speaker and output transformer Trutone A2-G
Thanks for the replies, I will check these ideas out and report back. murfmurf — 03:18 PM
Testing a speaker and output transformer Trutone A2-G
Sorry, my mistake. murfmurf — 03:07 PM
Testing a speaker and output transformer Trutone A2-G
MrFixr Honestly, I haven't done that yet and do not want to screw up the threads; maybe you could do it, or we could...morzh — 12:48 PM
Two small radios from France. Restoration and review.
Greetings; I think that it's possible that the assortment of components was the result of post war parts shortages, a...Arran — 12:18 PM
Philco model 38 code 121 not receiving signal.
Unfortunately I can't inject any audio into the volume control. It is in the primary circuit of the antenna coil, not in...Stormlord5500 — 09:32 AM
Philco model 38 code 121 not receiving signal.
Sounds good Gary I'll do that. I have plenty of stuff like that I can scrounge up. I am still kind of new to all this so...Stormlord5500 — 08:47 AM
Philco Battery-WWII vintage
Seems to me that this a general purpose or radio filament 6V battery of very high amp-hour capacity and very high "...MrFixr55 — 08:08 AM

[-]
Who's Online
There are currently 238 online users. [Complete List]
» 1 Member(s) | 237 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration