Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Recent finds
#1

Many thanks to my bud John Huffnagle for finding these sets for me!

Below is link to my Philco 38-14 Chairside. Not in bad shape, but dial/pointer are shot. Five tube AC/DC (yech) set, with a decent SW band of 2.3 to 8.0 MHz, which is great for nighttime DXing.

http://s1194.beta.photobucket.com/user/T...0Chairside

Below link is to my Philco 17X. MAN, I have wanted one of these sets for awhile now. Missing three wooden trim pieces, (one is on top of cabinet),but otherwise in nice shape. Chassis clean and ready to be brought to life!!

http://s1194.beta.photobucket.com/user/T...%20Console
#2

Those are great radio saves!

DDG

Pacing the cage...
#3

Congrats, Tom! Icon_thumbup

Both are great catches; especially the 17XS which may not be a highly desirable radio but is quite rare nonetheless.

--
Ron Ramirez
Ferdinand IN
#4

Two really nice sets!!! I had that CS set as a 39-7 no sw but was an ac set with pushbuttons. Wish I hadn't sold it a long time back.
Happy restoring!!
Terry
#5

You got a couple nice radios. You hardly hear of Philco chairsides, but people around here always crow about Zenith chairsides. Perhaps I need to locate a nice Philco one like that to balance things out. Icon_smile

No matter where you go, there you are.
#6

Philco built lots of chairside models, but I think they gave them a different name. One unfortunate thing is that they usually put low end chassis in the later chairside sets, like five and six tube jobs. I think that the best model from 1938 had a 38-7 chassis in it. It seems that most of the Philco chairside sets I've seen are older units like the 370 Lazyboy or the 71LZ Lazyboy.
Regards
Arran
#7

Man, that 17X looks like a BIG piece of furnitureIcon_thumbup

Gene
#8

Yes, It's as tall as the model 15!!




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently no members online.

>