Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Test Equip Allowed?
#1

Not quite a radio, but it is over 62 years old? Have received a Heathkit model TC-1 tube tester.

Meter movement is broken. Takes a 1 ma at 100 mv movement.

Any one know of a serviceable replacement source?

Hole that it fits is 3 inches. 3 5/16 H. x 3 3/4 W. scale viewing area.

If this is not in the right spot please feel free to move to proper location.

Thanks,

Gary
#2

I'm not sure but the last piece of Heath gear I saw with a meter used a Weston made meter. What part of the movement is broken? You could try opening it up and repairing it but it is a delicate job.
Regards
Arran
#3

The set screws that allow the coil movement to pivot are not able to be adjusted.
It appears that the dial side set screw is missing a point on the moving coil to allow it to be set properly in balance between the two set screws.

Thanks for the info, I'm trying to locate a suitable replacement to keep using the test set.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
IF can wire size and Rubber mounts?
Hello PHORUM members, I am still working on restoration of my PHILCO 37-640.  I want to start with rewiring the IF ca...georgetownjohn — 06:32 PM
Gilfillan Brothers Car Radio?
There is a Mission Bell model 19/19A that could be what you’re looking for, Riders vol 4. It has the tube line-up of: 0Z...Joe Rossi — 05:01 PM
Looking for verification of correct schematic.
Definitely 870044RossH — 01:12 PM
12' Philco
Wonder if the chassis was big too.daveone23 — 12:38 PM
Philco 38-2 Automatic Tuning
Hi Ron, I have sent Radio Daze my concerns with the dial so I guess we will see. They used my original to make the repro...dconant — 12:27 PM
Hickok AC51 tube tester
How does the  5W4 and 83 tube filaments get fed?martinj — 12:25 PM
462ron
Hi Dan, your original dial appears to be lighter, easier to allow light through. My original is similar except it’s crac...462ron — 12:07 PM
Philco 38-2 Automatic Tuning
I received my new 38-2 dial. I'm a little disappointed. As you can see in the picture the blues have a white shadow. The...dconant — 11:13 AM
Philco 38-2 Low Volume
I have been playing my 38-2 for a while now and it is doing very well. I did have to replace the 6A8 (osc) as it develop...dconant — 11:03 AM
Philco Speaker Spider
Hello, Does anyone with a 3 D printer make the spiders for those old Philco speakers? That might be a good idea for some...dconant — 09:41 AM

[-]
Who's Online
There are currently 3171 online users. [Complete List]
» 2 Member(s) | 3169 Guest(s)
AvatarAvatar

>