Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

My "new" 46-350 including box
#1

Check out this one that I just won http://cgi.ebay.com/ws/eBayISAPI.dll?Vie...%3AIT&rd=1

Ernie Sibberson
Firelands Vintage Radios
http://www.firelandsradios.com
#2

I saw that a few days ago. Nice to find these with an intact handle. Icon_smile
#3

Hey, I've got one of those too! Not as nice, but not bad, either!

Nice going!

Bill

Sent from my Pentium II on the AT&T Dial Network
#4

I have the 46-350 in my collection and also the 48-360 version with "alligator" leatherette covering.

[Image: http://www.philcorepairbench.com/images/46350.gif]
#5

Chuck did you rastle that gator down to get it's hide for your radio? Little did we know that during his spare time, Chuck makes Mick "Croc" Dundee look like a rookie.
#6

That's my evil Aussie twin.....
#7

Got this little beauty today. Pulled it out of its original box. Looks brand new--including the leather strap. Probably the second time its been out of its box. All I can say is WOW! Now I can sell the other two average ones I have. Icon_razz Icon_razz

Ernie Sibberson
Firelands Vintage Radios
http://www.firelandsradios.com
#8

Ernst;
Before you get rid of the others. Make sure you check out the one you just got. The tube out of it's base, and the swollen cap, makes me wonder if the owner plugged it in and blew the caps, and over heated the tube to where the solder melted off of the pins.
Not trying to be a bearer of bad news just looked suspicious.
Dan
#9

Dan, I think you are right. Need to replace the can. Got a couple of "spare" 46-350's that I can cannibalize--gosh I hate that!!!

Ernie Sibberson
Firelands Vintage Radios
http://www.firelandsradios.com




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently no members online.

>