Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Station tabs for 39-116 and Mystery Remote
#1

Hi-
I'm looking for some station call tabs to complete the restoration of my 39-116 console and Mystery Remote.

Any assistance you can offer will be greatly appreciated.

Thanks,
Lew
#2

Hi Lew

Barring the discovery of a new-old-stock set of original 1939 call tabs, you can make your own on your PC. Simply measure the size needed and go from there.

The tabs used on the radio's dial escutcheon are larger than call tabs used on other Philco models (those that do not have Mystery Control). So, unless you were lucky enough to run across an original set on eBay, you will probably have to make your own.

Tan lettering against a dark background will work well for the tabs which go on the radio's dial escutcheon. For the actual Mystery Control escutcheon, use dark brown letters against a tan background.

--
Ron Ramirez
Ferdinand IN
#3

Thanks for the advice, Ron.
I was hoping to stumble across a set of NOS tabs (or just 8 individual tabs), but barring that, I will have to make my own as per your suggestions.

Much obliged,
Lew




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Shadow Meter Bulb
Phorum members, I am trying to find the bulb # for PHILCO Shadow Meter part number 45-2180 that is from a 37-640 chassis...georgetownjohn — 06:53 PM
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM

[-]
Who's Online
There are currently 6046 online users. [Complete List]
» 3 Member(s) | 6043 Guest(s)
AvatarAvatarAvatar

>