1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Threaded Mode
Packard Bell Fans?
GregL
Junior Member
**
Posts: 41
Threads: 12
Joined: Jul 2013
City: Palm Springs, CA.
#1

10-10-2013, 02:10 AM
Hi Guys,
I just picked up a great Packard Bell Model RPC 92. Works pretty well. I'd like to locate a service manual and/or user manual for it. Any ideas?
Thanks!
Greg
Find
Radioroslyn
Phorum Expert
*****
Posts: 7,285
Threads: 268
Joined: Dec 2009
City: Roslyn Pa
#2

10-10-2013, 07:54 PM
A little too new for me it date about 1969. Not listed in Sam's
Terry
Find
GregL
Junior Member
**
Posts: 41
Threads: 12
Joined: Jul 2013
City: Palm Springs, CA.
#3

10-12-2013, 05:44 PM
Thanks Terry. I would like to replace the needle on the record player but I'm not sure how to determine the record player model number? It is a Gerrard.
Best,
Greg
Find
codefox1
Silent Key
*****
Posts: 2,128
Threads: 18
Joined: Oct 2008
City: Merrick, Long Island, NY
#4

10-13-2013, 11:34 AM
If this is a late 1960's Garrard record changer just about any modern magnetic cartridge can be fitted and balanced -- may be easier than obtaining a needle, but do take a close up picture which would help us determine what you have. Anything of this vintage should be gone over by a knowledgeable person to address safety and long term performance issues.
Find
Radioroslyn
Phorum Expert
*****
Posts: 7,285
Threads: 268
Joined: Dec 2009
City: Roslyn Pa
#5

10-14-2013, 10:43 AM
If you are able to have a look at the cartridge you might be able to find a model # on it. You can use that to lookup the needle.
GL
Terry
Find
BrendaAnnD
Phorum Expert
*****
Posts: 1,108
Threads: 89
Joined: Jun 2011
City: Tacoma State, Province, Country: Washington
#6

10-14-2013, 03:12 PM
It's most likely a ceramic cartridge in a phono from that era.
Find
« Next Oldest | Next Newest »




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
trying to identify this wire type
Thanks to all for the feedback. As Arran said, it is probably an older replacement and yes it has a grid cap so I will ...georgetownjohn — 09:32 PM
trying to identify this wire type
It's possible that the red wire, actually a grid cap lead, is a very old replacement, I can't remember seeing a pre 1939...Arran — 09:18 PM
Gilfillan Brothers Car Radio?
Hi everyone,  Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)