1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Threaded Mode
Zenith 5R312 voltages
Buzz
Senior Member
****
Posts: 358
Threads: 59
Joined: Jan 2013
City: Portland, Oregon
#16

11-08-2013, 09:43 PM
Hi:
Update on this Zenith radio.
Plan A
I hooked up a bucking transformer and it worked well....Price about $10.. Dropped voltage to 113V.
Howerever, because of the size of the transformer, it could not be mounted on the chassis.
Plan B
I installed a 25 Ohm 25W Vishay/Dale wirewound chassis mount type resistor. Price was about $4... It worked well, and dropped voltage to 115V...Filament voltage was spot on at 6.3V... The heat generated was not a problem, even afer 4 hours... very minor. Both ideas were good, and a great learning experience.
Thanks guys for all your input.Icon_clap
Buzz
(This post was last modified: 11-08-2013, 09:50 PM by Buzz.)
Find
Arran
Phorum Expert
*****
Posts: 4,657
Threads: 51
Joined: Sep 2008
City: Sandwick, BC, CA
#17

11-09-2013, 02:09 AM
You can hook up the bucking transformer off board, you basically make a custom built extension cord with the bucking transformer between one side of the line and the outlet.
Regards
Arran
Find
« Next Oldest | Next Newest »




Users browsing this thread:
[-]
Recent Posts
Correct model 84 Ac plug an cord type
From what I read Philco went to using brown rubber power cords in 1936, so cloth was used in the 1935 and earlier models...Arran — 11:25 PM
Correct model 84 Ac plug an cord type
Hi Bruce, I have not worked on an 84, but in general, power cords for almost any radio prior to 1938 was cloth covered...MrFixr55 — 08:34 PM
Restoring Philco 38-14
OK, well, so after staring at the sch again, I realized the problem had to be the #12/12A padder. I put a scope on the o...morzh — 08:15 PM
Correct model 84 Ac plug an cord type
Hello Bruce, I mostly use brown far as my cloth powercords go ! Here is the plug that I have used bakelite Acorn style...radiorich — 08:05 PM
Correct model 84 Ac plug an cord type
Looking for as correct as can find the right Ac plug an the correct colored cloth line. Ive seen many old photos but mos...Bruce — 04:13 PM
Restoring Philco 38-14
Rod Two Y-caps make sense if you use them from L/N to the chassis; this is only makes sense in the transformer radios...morzh — 10:11 AM
Restoring Philco 38-14
Mike, I'm curious about a specific use of he Y cap. Lately I've seen a single cap across the power transformer primary. ...RodB — 09:01 AM
Restoring Philco 38-14
hello morzh , That sounds like a plan ! Sincerely Richardradiorich — 07:45 AM
Restoring Philco 38-14
Richard, It helped some, but I still had the whining when engaging the rear power strip (I did not realize it was fro...morzh — 07:07 AM
Restoring Philco 38-14
Hello morzh, Yes , that dreaded hum in my room where i do alighment I have my cable modem and router plus desktop plus ...radiorich — 11:25 PM

[-]
Who's Online
There are currently 3196 online users. [Complete List]
» 2 Member(s) | 3194 Guest(s)
AvatarAvatar

>
  1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)