Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco Model 551-80 Mantle Clock ????
#1

Interesting question came up on the Philco Mantle Clock Radios. What Color was the Finials for these. I have owned both and mine were repro's that were GOLD.

I have an untouched Original 80 here now missing all 3. I also have another 551 which has 3 finials 2 broken 1 in good original Condition. They are stained in Natural Walnut.

My Question what was used. My Google of the 2 shows all GOLD so far.

Any Opinion on the matter. Having some re-pros made and wonder what I should order

Bob T
Wilmington, NC
#2

Hmmm. All of the ones I have seen were gold, at least on the 551s.

I do not recall what the 80 finials color was, they are rarer than the 551s.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

[-]
Who's Online
There are currently 6499 online users. [Complete List]
» 4 Member(s) | 6495 Guest(s)
AvatarAvatarAvatarAvatar

>