Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

91X winter project
#1

Hey all,
Well, now that the long nights and cold weather have come to Wisconsin, I can start another project. I bought this 91 chassis on Ebay awhile back to use for parts on a 91 cathedral I have. After looking at it I realized that this was the chassis for the dual speaker console of which I just happen to have an empty cabinet forIcon_thumbup So, I'm starting restoration on the chassis and will do the cabinet next spring. The chassis is pretty dirty but is complete, and it looks like the only repair it ever had was one filter cap replaced. Suprisingly, I even have a matching Mershon cap to replace it with. Unfortunately, the shadowmeter coil tests open, I'll have to look at it and maybe I will be able to repair it rather than rewind it.
[Image: http://i1160.photobucket.com/albums/q500...444d12.jpg]
[Image: http://i1160.photobucket.com/albums/q500...d98d17.jpg]
[Image: http://i1160.photobucket.com/albums/q500...cc7867.jpg]
[Image: http://i1160.photobucket.com/albums/q500...1efc55.jpg]
Should keep me busy for awhile!
Kevin
#2

Kevin that looks like a good winter project. Sure looks unmolested. Are the globe type tubes original and has that transformer in upper middle of pic been hot ?
Good luck.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Shadow Meter Bulb
Phorum members, I am trying to find the bulb # for PHILCO Shadow Meter part number 45-2180 that is from a 37-640 chassis...georgetownjohn — 06:53 PM
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM

[-]
Who's Online
There are currently 5602 online users. [Complete List]
» 1 Member(s) | 5601 Guest(s)
Avatar

>