Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 40-180: the radio plays!
#1

Got the old beater fired up and playing pretty good now. It still needs to be aligned and tweaked a bit.

I had a number of problems with this set: replaced all electrolytic and paper caps, rebuilt the bakelite cap. The RF tube 1232 was supposed to have its grid connected to ground, but it wasn't. I had to take apart the volume and tone controls and clean them. I also rewound the oscillator coil, before it wasn't working at all. There were a few caps just laying in the chassis not connected to anything, so I had to figure out where to connect them. I also had to get a new 6J8G and an 84. Put in a lot of new wiring to replace the rubber coated wires that deteriorated.

The tone controls were eventually removed. The radio sounded better that way.

radlam
#2

Congratulations. Always good to hear that another Philco has been brought back to life.

--
Ron Ramirez
Ferdinand IN




Users browsing this thread:
[-]
Recent Posts
VTVM meter moves when my hand is next to it & not on
Haha! I hope so. It seemed rather lost and forgotten languishing in the frozen Northeast of England.EdHolland — 02:36 PM
VTVM meter moves when my hand is next to it & not on
Ed - it's in the Cayman's enjoying the good life.RodB — 02:14 PM
VTVM meter moves when my hand is next to it & not on
Static electricity - but the other chaps beat me to it again. I've seen this before with analogue meters. I've also ...EdHolland — 01:56 PM
Need to purchase some accessories for restoration of my Old Philco Radio
Hi Paulo, Welcome to the Philco Phorum. I can see why you want to find good reproduction parts. That is a bea...MrFixr55 — 11:10 PM
HiFi (Chifi) tube amp build - but my own design.
Tim, I have some bakelite sockets in my work shop that I can dig up. I believe quite a few are NOS. I will take photo...RodB — 10:03 PM
Philco 610B oscillator wiring
> The cathode as noted is wired directly to the ground side of the heater filament for that tube, not to the #17 and ...Radioroslyn — 08:12 PM
HiFi (Chifi) tube amp build - but my own design.
Tim; I noticed your post a little late, but I would take one of the junk sockets and try to break a chunk out of it wi...Arran — 08:07 PM
Need to purchase some accessories for restoration of my Old Philco Radio
Here is a list of resources found in our online library that you might find useful. Mike's Gobs of Knobs email addres...klondike98 — 01:46 PM
First Radio restoration
Hi Tubeman, Welcome to the Philco Phorum.  Phamily Phriendly Pfun with Phine Pholks Phull of Philco Phacts. (See a p...MrFixr55 — 12:33 PM
First Radio restoration
You could post in the WANTED ADs section here on the Phorum and see if anyone has an RF generator that they want to sell...klondike98 — 11:55 AM

[-]
Who's Online
There are currently no members online.

>