Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Hey Ron, would you be interested in this?
#1

Buddy of mine is moving and needed some help cleaning out his ham shack.  He had a LOT of stuff to get rid of and told us to take whatever we liked.  Amongst the car load of stuff I came back with was this Fischer 160T.

[Image: http://i.imgur.com/RyksBWjl.jpg]

[Image: http://i.imgur.com/eZjE6QGl.jpg]

[Image: http://i.imgur.com/uQHvVvZl.jpg]

It's in pretty good shape, but needs a good cleaning both inside & out.  It powered up after I put in a new fuse.  Radio tried to pull in some stations, which it'll probably do better after the pots are cleaned and a proper antenna is hooked up.  
#2

Sure - check your PM inbox.

--
Ron Ramirez
Ferdinand IN




Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
IF can wire size and Rubber mounts?
Hello PHORUM members, I am still working on restoration of my PHILCO 37-640.  I want to start with rewiring the IF ca...georgetownjohn — 06:32 PM
Gilfillan Brothers Car Radio?
There is a Mission Bell model 19/19A that could be what you’re looking for, Riders vol 4. It has the tube line-up of: 0Z...Joe Rossi — 05:01 PM
Looking for verification of correct schematic.
Definitely 870044RossH — 01:12 PM
12' Philco
Wonder if the chassis was big too.daveone23 — 12:38 PM
Philco 38-2 Automatic Tuning
Hi Ron, I have sent Radio Daze my concerns with the dial so I guess we will see. They used my original to make the repro...dconant — 12:27 PM
Hickok AC51 tube tester
How does the  5W4 and 83 tube filaments get fed?martinj — 12:25 PM
462ron
Hi Dan, your original dial appears to be lighter, easier to allow light through. My original is similar except it’s crac...462ron — 12:07 PM
Philco 38-2 Automatic Tuning
I received my new 38-2 dial. I'm a little disappointed. As you can see in the picture the blues have a white shadow. The...dconant — 11:13 AM
Philco 38-2 Low Volume
I have been playing my 38-2 for a while now and it is doing very well. I did have to replace the 6A8 (osc) as it develop...dconant — 11:03 AM
Philco Speaker Spider
Hello, Does anyone with a 3 D printer make the spiders for those old Philco speakers? That might be a good idea for some...dconant — 09:41 AM

[-]
Who's Online
There are currently no members online.

>