Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

CRAWL SPACE FIND
#1

Hello everyone,
I recently foun a turntable while cleaning out a crawl space at the house I bought. I was wanting to know if anybody could help me identify the year of it. I would also like to restore it. I plugged it in and it plays fine. Any help would be apprec iated.
PHILCO MODEL # K-1526-121 is the only number I can find on it
Thanks
Jay Cookson
jay.cookson@yahoo.com
#2

Based on that letter K, it probably dates back to 1962.

B - 1954
C - 1955
D - 1956
E - 1957
F - 1958
G - 1959
H - 1960
J - 1961
K - 1962

and so on...

From 1937 to 1953, Philco used the last two digits of the model year (i.e. 37-610, 48-1274) as a prefix to its model numbers instead of letters as above; the letters were adopted in the 1954 model year.

--
Ron Ramirez
Ferdinand IN




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! GaryGarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM

[-]
Who's Online
There are currently 4204 online users. [Complete List]
» 3 Member(s) | 4201 Guest(s)
AvatarAvatarAvatar

>