Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 81 B Dial replacement
#1

       BIG Question,,,I have a Philco 81B,,,which has the Police Band...On thee Dial,,does it show the 2nd Band,like a  Philco 620, or any other radio that has multi bands on it…Because , My doesn't have it,,,BUT I do have the switch for it,, just need a- alignment for it..---Thanks You all….
#2

My 81B shows frequencies for the "police" band on the dial:

[Image: http://i326.photobucket.com/albums/k420/...g~original]

[Image: http://i326.photobucket.com/albums/k420/...g~original]

--
Ron Ramirez
Ferdinand IN
#3

        Thank You,,Ron,,,,I don't have that on the scale,,,now know what to look for,,,Maybe I can find one New some were,,,will look for one,,,  Cheers
#4

I did notice that one of are suppliers replacement dials lists the 80 and 81 using the same dial. I too have an 81 with an 80 dial on it.

Terry
#5

        Well,,,,Mark Oppat says that he does NOT have thee dial with the S.W. numbers under the scale,---he has 27-5009 and B-7989 ,,and Radio Daze only has B-7989,,,soo,,,I must have B-7989 ---ALSO (my mistake on number before) ,,, So I presume that the one  ,,,that I would need  would be the B-7889,,,which I can not find,,,




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM
Philco 42-390, code 121 speaker
>>A closer examination of the very small print schematic indicates that the speaker is a PM type. This shows a ...morzh — 05:18 PM
Philco 60 Squealing
Litz is typically tinned by simply rubbing it with the soldering iron tip while immersed in solder (and a bit of rosin f...morzh — 05:14 PM
Philco 6K7
The suppressor grid (if by G3 you mean the S) is usually at the Cathode potential, which in this caes is GND. I am not ...morzh — 05:10 PM
Philco 16B Parts
Thanks for the reply. Unfortunately the radio was removed before bidding was over so I didn't get a chance to bid.dconant — 04:10 PM
Philco 16B Parts
Hi Dan, Mike is correct, there's a lot of painted stuff on the chassis but it looks pretty good. The sm is all there,sp...Radioroslyn — 03:50 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Hi Cap'n Clock, Unfortunately, I do not have this radio.  This is a shame because this should be a good performer.  2A...captainclock1988 — 03:43 PM
Philco 42-390, code 121 speaker
Using a 5W  1.5k  ceramic resistor in place of the field coil and using a 4 ohm PM speaker, I was able to bring the radi...Stevelog — 02:57 PM
Philco 60 Squealing
I have taken out the 2nd IF and found a problem or not. I believe the coils are litz wire. There is a very small strand ...dconant — 02:13 PM
Philco 6K7
I am restoring a Philco 37-60. The am reception is very good, but the shortwave is very weak. Run 6 Philco removes the g...bobbyd1200 — 01:35 PM

[-]
Who's Online
There are currently 4380 online users. [Complete List]
» 1 Member(s) | 4379 Guest(s)
Avatar

>