[CWill51]

I am attempting my first capacitor block restoration on a Philco 112, part 3754.  I found schematics and it appears the capacitors for the block are one 0.05uf, two 2.0uf, two 0.5uf, two 0.15uf and one 1.0uf.  It's a little hard to read the schematics. Can anyone confirm this and should the voltage for the caps be 630V to be on the safe side?
Thanks.

[Nathan Slingerland]

Here are the values from service bulletin #54:

   

I would use film caps for all of those (the ones I buy are typically rated at 630V).

[palegreenthumb]

There are discrepancies between the caps lists you two have given.

[Nathan Slingerland]

Yes - there are. I'd go by the service bulletin, unless somebody else knows better.

[Warren]

If you can go e.me the number on the block I should be able to.look up the  caps.for you.