Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco Electrostatic Speaker?
#1

I saw this yesterday on ebay and am wondering what Philco models may have used it.
http://www.ebay.com/itm/Vintage-PHILCO-3...SwqYBWnmSd
It looks like it definitely would have been used in a radio floor standing console, but I have not seen a Philco model that I could definitely say it was used in.

Joe
#2

's been there awhile......

People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.
#3

    I thought that was a toaster,,lolololol
#4

 I don't know what Philco models would have contained electrostatic speakers, if any. The only electrostatic speakers that I have seen were tweeters used in late 1950s and 60s European built radios and combo units and those were no where near the size of that thing. To me that unit looks more like a large appliance part of some kind, possibly from an air conditioner, maybe it's an electrostatic filter rather then a speaker? It looks like it would fit around a blower housing.
Regards
Arran
#5

Several high end Philco console hi-fi models made from the 1955 season through at least the 1960 season used various types and sizes of electrostatic tweeters. There was also a table model phonograph made in 1955 and 1956 which had a small electrostatic tweeter mounted in the center of the grille.

--
Ron Ramirez
Ferdinand IN




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Cannot Adjust an IF Transformer’s cores
Outstanding work indeed. I wish I could come up with solutions like this.slford310 — 11:16 PM
Cannot Adjust an IF Transformer’s cores
The abilities of our 'Phorum Pholks" never ceases to amaze me! Fantastic fabrication, Joseph! I'm waiting now for...GarySP — 08:27 PM
PT-6 antenna connections
Thanks. I never realized that was a notch noted in the schematic as described. I’ll recheck my wiring.bridkarl — 08:13 PM
Cannot Adjust an IF Transformer’s cores
Thank you! I was quite new to the Phorum when I started this post, so I feel like it might be advantageous to publish a ...jrblasde — 08:07 PM
PT-6 antenna connections
Notice in the schematic the notch at the bottom of the antenna coil is between pins 3 & 4. Yes, pin 6 of the 7C6 is...RodB — 07:34 PM
bridkarl
I have two PT-6 chassis. On both there is a blue wire that runs from the above chassis transformer to pin 6 of 7C6. So t...bridkarl — 07:23 PM
Cannot Adjust an IF Transformer’s cores
Joseph, now you are an engineer!!RodB — 06:37 PM
PT-6 antenna connections
Hi, reading your explanation I can see the confusion. If you take it one connection at a time it should result in a desi...RodB — 06:34 PM
Cannot Adjust an IF Transformer’s cores
It works! I received the PCBs this morning in the mail, and put everything together. I reused the base from the original...jrblasde — 04:32 PM
PT-6 antenna connections
I seem to have lost my way on this PT-6. I see the antenna aerial transformer schematic - I’m reading pins 1 through ...bridkarl — 12:30 PM

[-]
Who's Online
There are currently 4268 online users. [Complete List]
» 1 Member(s) | 4267 Guest(s)
Avatar

>