Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Picked up a new Philco
#1

Hi;
I picked up a new-old Philco on the weekend at of all things an old car swap meet. It's a Philco model 40-81, code 122, a cloth covered portable with four tubes. It isn't in bad shape, just dirty, the back is missing but everything else is still there. I suspect the battery pack must have leaked and ruined the back as the chassis has some rust spots. What's interesting is that the set has a built in loop antenna, but it wasn't mounted on the back it was would around the outside of the cabinet under the cloth cover. It also has a rather large speaker, five or more inches. Apparently the B+ was only 67-1/2 volts, I didn't know that portables from then were made to run on such things in 1940. I will clean it up and see if I can get it going, there are only five condensers in the whole radio (aside from micas) so not much to go wrong other then the rubber wire. Here's a picture of a similar set for reference, I don't have one of mine yet:
http://www.philcoradio.com/gallery/1940a.htm
Best Regards
Arran
#2

I have a 40-82 (uses the same chassis as the 40-81) that I picked up a couple of years ago at the annual Gypsy Caravan in St. Louis. I'm not into portable sets but this is in pretty nice condition and I felt like I needed to buy something after spending $20 on the early-bird admission to the event. It's been sitting on the shelf waiting to be restored. One of these days I'll put it on the bench and maybe have Battery Maker build a battery for it.

Sean
WØKPX




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
The list of my radio & TV collection!
A little bit of positivity in our feed... My new video... Test - the Philco 16B vs Philco 37-116 de Luxe / Test - the ...RadioSvit — 12:14 PM
Refinishing Ideas
Thanks. I will look into. Billpoulsbobill — 11:23 AM
My Philco 37-116 Restore
Why do the flood lights have 2 wires running to the shell of each light when the inner conductor only has one to each? ...dconant — 10:54 AM
Philco 46-480 Electronic Restoration
OOPS!! if there is a "flag" running up the side of the tube that touches the shield, then yes, a shield belon...MrFixr55 — 10:03 AM
Philco 46-480 Electronic Restoration
Thanks for pointing out that shield! I will try to find out where else it may belong. I simply installed it back where i...jrblasde — 10:02 AM
Philco 46-480 Electronic Restoration
Very nice job. A real contrast between how easy the main chassis is to work on, vs how tightly the RF chassis is packed...MrFixr55 — 09:31 AM
Philco 46-480 Electronic Restoration
After sleeping on it, I believe the issue is that I may have forgotten to install a ground connection between the RF cha...jrblasde — 09:21 AM
Refinishing Ideas
Hi Poulsbobl, I think that you could get away with it.  In the Philco Library, there is a parts listand specs for sp...MrFixr55 — 11:54 PM
Philco 46-480 Electronic Restoration
The sleeving for the transformer arrived early, so I went ahead and finished reassembling. The chassis looks far better ...jrblasde — 10:15 PM
Philco 610B oscillator wiring
I don't know what you are referring to when you say "tube cathode ground". Ground is a connection to the chass...RodB — 05:56 PM

[-]
Who's Online
There are currently 753 online users. [Complete List]
» 1 Member(s) | 752 Guest(s)
Avatar

>