Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Picked up a new Philco
#1

Hi;
I picked up a new-old Philco on the weekend at of all things an old car swap meet. It's a Philco model 40-81, code 122, a cloth covered portable with four tubes. It isn't in bad shape, just dirty, the back is missing but everything else is still there. I suspect the battery pack must have leaked and ruined the back as the chassis has some rust spots. What's interesting is that the set has a built in loop antenna, but it wasn't mounted on the back it was would around the outside of the cabinet under the cloth cover. It also has a rather large speaker, five or more inches. Apparently the B+ was only 67-1/2 volts, I didn't know that portables from then were made to run on such things in 1940. I will clean it up and see if I can get it going, there are only five condensers in the whole radio (aside from micas) so not much to go wrong other then the rubber wire. Here's a picture of a similar set for reference, I don't have one of mine yet:
http://www.philcoradio.com/gallery/1940a.htm
Best Regards
Arran
#2

I have a 40-82 (uses the same chassis as the 40-81) that I picked up a couple of years ago at the annual Gypsy Caravan in St. Louis. I'm not into portable sets but this is in pretty nice condition and I felt like I needed to buy something after spending $20 on the early-bird admission to the event. It's been sitting on the shelf waiting to be restored. One of these days I'll put it on the bench and maybe have Battery Maker build a battery for it.

Sean
WØKPX




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
My Philco 37-116 Restore
Measuring from center tap like the tube voltages show. Cap 127 is isolated from ground. Cap 127 shown in upper left of p...dconant — 08:05 AM
My Philco 37-116 Restore
Are you measuring relative to the centertap or the GND?morzh — 11:57 PM
Philco 610B oscillator wiring
Still not clear on the wiring interface between the 6A7 and oscillator. After refering to the available schematics and s...Tubester — 07:18 PM
Refinishing Ideas
My 37-116 code 121 is the best sounding radio i have...a daily driver. Since we are talking about "changes". ...poulsbobill — 07:18 PM
My Philco 37-116 Restore
Hello, I finally got brave enough to take the cans off the Expander Unit. Got the grid cap wires replaced and back toget...dconant — 06:50 PM
Zenith H725
I got into the first AM IF can today, and found its mica was cracked. Amazing that it was still working. This one makes ...EdHolland — 06:10 PM
Philco model #20
AHH HA , I got it and can’t thank you fellows enough , when I changed the capacitors I took the advice and did not unsol...onlyrick — 02:24 PM
Zenith H725
Hello Ed, yes, I like letting projects run for few days to make sure they don't start acting up . Sincerely Richardradiorich — 01:03 PM
Philco 46-480 Electronic Restoration
I am almost finished with this restoration. All which remains is the power transformer. I cleaned it up some time ago, b...jrblasde — 12:41 PM
Philco model #20
I seem to recall in some TRF sets there being a Local/Distance toggle switch that removes the B+ from the first 24 rf tu...RodB — 09:46 AM

[-]
Who's Online
There are currently 774 online users. [Complete List]
» 1 Member(s) | 773 Guest(s)
Avatar

>