Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

philco tuning capacitor
#1

Hi every one I am new to this hope I am doing it right here goes am trying to repair philco mod 41-260 tuning cap hanging up I have tryed about all i know doe;s any one know where I can get one or have it repaired
Thanks Tom ps p/n 31-2481R
#2

Welcome to the Phorum!
Icon_wave

I moved this to the restoration section to see if any one can offer sdvice for a repair. If you want to see if any one has a spare, put a post on the wanted section.
#3

Tom

Welcome.

Two requests:

1. Could you please use some punctuation, it is a bit hard to read one long sentence with no commas whatsoever.
2. What does "tuning cap hanging up" mean? Tuning cap is not a computer. We can make guesses as to what you mean, but it is better if you explain the symptoms.

Start from the beginning, what was done to the radio (like, was it re-capped etc), what it does when you do something to it (power up, sound, tuning, performance), etc.

People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.
#4

Mike;
  I can only take a guess but it sounds like the tuning capacitor might be seized up, but I too will await clarification from the original poster to find out if that is what he meant. Short of severe corrosion or mechanical damage there isn't really a lot that can go wrong with a tuning cap, usually it's a matter of cleaning and new lubrication in the bearing points.
Regards
Arran




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Rusty Tuning Condenser
If you have rust between the vanes, I wonder how you get the NJ in between, and how you then wipe it off.morzh — 12:02 PM
Philco 60 Squealing
If the noise is still there, the OPT might just be OK. Or so we hope.morzh — 12:01 PM
Philco 60 Squealing
You would probably be replacing the OPT.RodB — 10:54 AM
Philco 60 Squealing
I have been playing the radio for a while now and doing well. Turned it on today and all I got was a whole lot of noise....dconant — 09:39 AM
Rusty Tuning Condenser
Thanks guys. I think I'll give the Naval Jelly a try since I can better control where it goes.dconant — 09:23 AM
Philco Model 80 Transformer resistance
Just forget this number, it is useless anyway. Simply proceed with your project.morzh — 10:08 PM
Philco Model 80 Transformer resistance
My $0.02 is that it is a misprint. I tried to look up the value for the similar 84 and 37-84, and ther is no resistance...MrFixr55 — 09:51 PM
Philco Model 80 Transformer resistance
Thanks for the quick reply! Hmm...well that's good, so what am I seeing that's 1042 ohms on the schematic for the pow...Mike L — 08:46 PM
Philco Model 80 Transformer resistance
The DC resistance of the primary is 8 to 9 Ohm.morzh — 07:54 PM
Philco Model 80 Transformer resistance
I have a feeling the primary winding on the power transformer is bad. My resistance reading on the primary side is 9 ohm...Mike L — 07:48 PM

[-]
Who's Online
There are currently no members online.

>