Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Talking House Transmiter
#1

I wasn't sure where to put this but since it related to my Zenith - here it is:

I can remember posts about poor audio quality from these transmitters.

I have had one on the shelf for years. Got it out today to use with the 1000Z (see recent post).
Works great with my Samsung phone which I don't want to leave behind - very distorted on my old Blackberry. You can't turn the level down low enough not  to over modulate. I'll either have to pad it down or use another device. I have heard this complaint before but never tested one to find out why.

Somebody may have already figured this out. But just incase it can help. Seems like the stated 500mv input is wrong.

EDIT - seems that the advertised AGC might be active only in the "cal" mode. So retune the freq and then set it back. It will force it to calibrate.

"I just might turn into smoke, but I feel fine"
http://www.russoldradios.com/




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
Wavetrap no longer matters.morzh — 05:19 PM
Philco 60 Squealing
Rod, I had checked out your suggestions but did not help. I did solder the ground rivets to the chassis as Chas suggeste...dconant — 04:52 PM
37-690 Bass Choke Replacement
Yeah, I know, Mouser and Digikey don't have "big iron" components. For some reason Philco was messing with the...Radiodial — 04:25 PM
37-690 Bass Choke Replacement
Yes, I just had to deal with that while repairing the 37-604 Philco. Exactly that value choke was gone. And the current ...morzh — 03:52 PM
37-690 Bass Choke Replacement
Ah, now where to find one. I've into this before on smaller sets, I now recall. Hammond makes one that is only rated...Radiodial — 03:27 PM
Philco 38-7 Speaker
Ask the admins to put them together. As for the renaming, while inside the thread, you simply press "New reply&quo...morzh — 02:23 PM
37-690 Bass Choke Replacement
This is the parts catalog. 32-7528 choke is 65H, 10mA, 2,250 Ohm inductance. Find a suitable one.morzh — 02:18 PM
37-690 Bass Choke Replacement
While troubleshooting the no bass amplification issue, I think I found the culprit. The choke #104 is reading 164K ohms....Radiodial — 01:42 PM
Philco 60 Squealing
Your IF transformers are tuned to the resonant frequency they were designed for. When you observe the bell curve they di...RodB — 01:35 PM
identify very thin wire for replacement on 37-640
Thanks so much for your help!  I really could not have gotten this far without the kindness of you and other members.  T...georgetownjohn — 11:50 AM

[-]
Who's Online
There are currently 3850 online users. [Complete List]
» 1 Member(s) | 3849 Guest(s)
Avatar

>