Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 29-124 Chairside
#31

Read the bottom portion of the 2nd page of the above literature link that Nathan posted.  The "Inclined Sounding Board" in this unit allows the speaker to be against the chair without interfering with sound.  Interesting.

Craig R
#32

I thinks it's unusual that it has speaker cloth by the dial also. Maybe some sound bleeds out there too.
#33

(04-15-2016, 02:58 PM)SteveG Wrote:  I thinks it's unusual that it has speaker cloth by the dial also. Maybe some sound bleeds out there too.

That must be an integral part of the design.

Craig R
#34

I agree.  I think the top grill design must have been something about projecting the sound upward.  The 630CSX didn't have it, however, so maybe it didn't pan out with customers.

The 630CSX design says customers wanted the sound to project out into the room more, rather than upward.  But that upward-facing grill is absolutely the defining feature of the 28/29CSX.




Users browsing this thread: 6 Guest(s)
[-]
Recent Posts
Shadow Meter Bulb
Not sure if anyone has tried this but there are 6.3 volt miniature lamps in bayonet and screw-in base options available ...GarySP — 11:31 AM
Shadow Meter Bulb
Any 6.3 volt pilot light will work. I would use the brightest one I could find in my workroom. Be sure the dial is clean...RodB — 10:45 AM
HiFi (Chifi) tube amp build - but my own design.
Tim, nice write up and thanks for sharing !! Sincerely Richardradiorich — 02:47 AM
HiFi (Chifi) tube amp build - but my own design.
Well, this was a real "Hum-Dinger" :lol: ! This will be kinda long, but hopefully it will help others having t...TV MAN — 01:55 AM
Shadow Meter Bulb
Phorum members, I am trying to find the bulb # for PHILCO Shadow Meter part number 45-2180 that is from a 37-640 chassis...georgetownjohn — 06:53 PM
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM

[-]
Who's Online
There are currently 7586 online users. [Complete List]
» 1 Member(s) | 7585 Guest(s)
Avatar

>