Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 38a in stunning matt mustard
#16

Steve;
  Whenever you buy a painted cabinet, especially over a long distance, it's always a gamble as to what may be underneath. In some cases you get lucky, and find out that the tacky paint job was the result of bad taste, then other times you find out that it was for a coverup. Thankfully most of the time it's for the prior reason rather then the latter.
Regards
Arran
#17

Its not really all that bad... it tells a story about its past so I may just tidy it up and leave it. Its on the backburner now anyway because the repairs will take a bit and the chassis is quite rusty so thats probably a full strip (and I don't have time / energy to spend on building a power supply for it)... I might see if I can get my 97 going instead and think about what to do with this...

There are no personal problems that can't be overcome with the liberal application of high explosives




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
[split] New member...
You may have to start further back with your signal injection at the IF signal grid, then tune the second IF transformer...RodB — 10:28 AM
[split] New member...
Well, with the replacement tuning assembly, I have finally put the unit back together and aligned the dial.  The first s...HowardWoodard — 01:01 AM
Philco Model 16 wiring question
Well, finding a short is easy. Like I said, disconnect the transformer's secondary windings and see if it persists. If...morzh — 09:48 PM
Restoring Philco 96
Nice one!Stan the Man — 09:37 PM
Restoring Philco 96
I have eventually replaced the speaker and shot the video, which only shows the upper part of the dial as the hum is ver...morzh — 09:24 PM
Rogers Majestic R-646
Kinda weird to see both open Nothing weird if you remember that this radio is about 100 years old  :)Vlad95 — 07:49 PM
Philco 42-345 Restoration/Repair
I believe I'm making progress, resistors have been rechecked and corrected, removed that ugly blue capacitor and more wi...osanders0311 — 07:38 PM
Philco Model 16 wiring question
Thanks Morzh Yes I recapped everything and replaced almost all the resistors as well. I redid #99 with .015 safety ca...bobclausen — 07:11 PM
Philco Model 16 wiring question
Well...pull out every single load of the transformer. For every winding. Unsolder if needed. Then re-do your dim bulb....morzh — 07:02 PM
Rogers Majestic R-646
Kinda weird to see both open, but once you get it up and running, really pay attention to your sound. Listen for loud cr...TV MAN — 06:59 PM

[-]
Who's Online
There are currently no members online.

>