Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

ID this Bracket on Philco 16B chassis
#1

Can't figure what it was used for.
Original to this chassis.

Bob T


Attached Files Image(s)
   
#2

The bracket does not belong there. Someone added it for who knows what.

Steve

M R Radios   C M Tubes
#3

+1 what Steve said.

--
Ron Ramirez
Ferdinand IN
#4

I think it was used tohold an antenna maybe.

People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.
#5

Like they said.
Definitely not factory original.  Dealer or owner add-on.
#6

Attached to the other side of this bracket is the Wave Trap Assembly (PHOTO)

Inductive Wave Trap with Compensating Assembly

Items 3 and 4 on Parts list

It is covered with a soft crystal looking material. Do not know what that is

Will clean later and see if coil still good.


Bob T

The Crystal Material looks like the goo when a Battery leaks.
Just had one yesterday AAA Battery leaked and looked the same.


Attached Files Image(s)
   
#7

I believe that Bracket was added.
Its use was to hang the Antenna Wire on

I saw another one , not same Bracket , but had about 20 feet of wire wrapped and hung on the bracket.

So I stand by my answer and that is all there is to it.

No don't try to change my mind, it is made up.



Any other ideas Icon_crazy 

Bob T




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 16B Parts
The 16B's in the tombstone cabinet sport a 10 1/2" spkr vs the older cathedral sets which uses an 8". The p/p ...Radioroslyn — 12:58 AM
Philco 38-7 Oscillation
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 11:16 PM
Philco 38-7 Speaker
I know that when I first started working on this radio, I did not even have a speaker. Once I finally found one it was n...tludka — 11:00 PM
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM

[-]
Who's Online
There are currently 2561 online users. [Complete List]
» 1 Member(s) | 2560 Guest(s)
Avatar

>