Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Detrola Series 175 Push Buttons
#1

I have just completed restoration of a Detrola Series 175. When I
received the radion all 8 push buttons were missing and I am having
trouble locating replacements. If anyone has this model and can send
me a couple of good pictures of the push button, along with its
approximate dimensions, I would appreciate it. If you need a picture
of the radio, please email me.
#2

Hi John,
I know it's been a long time since this was posted, but I have a Truetone 727 a lady wanted me to repair. It has all the buttons on it and I'd be happy to send photos and measurements.

That thing is quite a beast. I know the trans is ok, and the motor tuning does work, however it slips a little on the tiny gear.
I might be able to slightly move the gear housing over a couple of mm to make it mesh again.
The tuning ring, I am still going to have to figure it out. I see other models have the same setup.
Will get back to you ASAP.
Gary.
#3

Gary:
I am a little confused. I need the 8 push buttons so I don't understand what you have sent me.
John
#4

Hi John,
I don't have any pushbuttons to send, but I was going to send photos and measurements of what they look like.
I'll email you photos this afternoon.

Just the plastic part is missing? Or the whole plastic and brass contact rod?

I think that if you had a small lathe or even some plastic rod material, (swirled brown plastic) you'd be able to make your own. I'm going to make the photos now.

Gary.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 91 Speaker Replacement
The spider is glued on the cone and so is the voice coil. I think you can use a cotton swab dipped in acetone and carefu...RodB — 02:42 PM
Restoring Philco 37-604C
Yes I saw that. If I knew, I'd probably try to arrange for getting it myself. But I have just got one. Which does not m...morzh — 01:44 PM
Philco 38-2 Automatic Tuning
When you push the lever, you are supposed to rotate the disk to the desired station. Then the magnetic tuning will acqu...morzh — 01:42 PM
Philco 38-2 Automatic Tuning
I figure out the muting from another picture that helped. Now I need to know how the automatic tuning works. When I push...dconant — 12:11 PM
Philco 91 Speaker Replacement
How would I go about removing the spider from the cone?dconant — 12:04 PM
Philco 38-2 Automatic Tuning
Hello, I am having trouble getting my automatic tuning to stay unmuted. If I play with the tuning handle I can get it to...dconant — 10:51 AM
Does anyone make photofinish replacements?
Here’s the link to the DIY photofinish section of our site: klondike98 — 09:46 AM
Delco car radio Peko vibrator converstion issues
Hi Richard, Thx for posting the schematic.  As I remember as a kid, these were great performers for the time, likely...MrFixr55 — 08:56 AM
Delco car radio Peko vibrator converstion issues
hello mr Fixr, The Electro  Powersupply that I am powering the radio with has a huge choke plus a 10,000ufd electrolyti...radiorich — 10:58 PM
Delco car radio Peko vibrator converstion issues
How about putting a choke in the power supply? The big cap was likely an attempt to stabilize the DC. Kids who cre...MrFixr55 — 09:19 PM

[-]
Who's Online
There are currently no members online.

>