Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Spring Cleaning/Listening
#1

Had a couple of free hours to rummage in the cellar today. Dusting, listening, arranging and paying some attention to some sets that have not been getting a lot of play. Managed to use some Novus 2 that I think may have gone bad and made a splotch on one of the bakelites! Ugh Icon_sad.

https://www.flickr.com/photos/92577012@N...9176157940

Anyway.....

Emerson 322, Fine player and nice dial, even with a ballast it sounds better than I expected, ballast=cheaper set, sometimes I guess.

Trutone D905, Cabinet by Fred Taylor, I splurged. Also has a ballast but good size speaker, nice sound.

Silvertone 6051, very 40's looking IMHO. 6 tubes, pretty good player.

2 Zeniths, R723 and a relative whose model# escapes me now......R723 is one of my faves.

I will have to rotate upstairs soon.

What else is down here.

Paul 

Tubetalk1
#2

  You got some nice table radios there Paul. Always a good idea to power them up every so often.
I had my Atwater kent model 37 playing last week, been awhile.
#3

Yeah Paul........Move them around and give them all a chance to be listened too. Thats what I do.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Shadow Meter Bulb
Phorum members, I am trying to find the bulb # for PHILCO Shadow Meter part number 45-2180 that is from a 37-640 chassis...georgetownjohn — 06:53 PM
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM

[-]
Who's Online
There are currently 5384 online users. [Complete List]
» 2 Member(s) | 5382 Guest(s)
AvatarAvatar

>