Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 87 Help Needed
#1

Hi, I just got a Philco 87 at the local thrift store and I'm going to start and restore it. It looks to be all original minus a few parts.(still has most globe style tubes). It's missing the three smaller knobs (tuning knob is there). Can they be found? About half the dial is worn. Anyone knows if it can be restored? Also the decretive work in the speaker opening, was that on all modle 87's? I saw on a philco site one had a tapestry print. Is that also correct? Any and all help would be appreciated. thanks, Richard
------------------
Richard
#2

Hi Richard

Yes, knobs and reproduction dial scales are readily available; sources for these may be found on this site's Parts Sources page:
http://www.philcoradio.com/resource.htm

Earlier Model 87 lowboys have the decorative cutouts in the speaker grill, and plain gold cloth identical to that used in Model 20. Later 87 lowboys use the "tapestry" cloth, with no grille cutouts.

Reproduction cloth may be found at http://www.grillecloth.com .

--
Ron Ramirez
Ferdinand IN
#3

Thanks Ron, I ordered the speaker cover print and started looking for the other parts. This is the oldest one yet I have restored. Electronics pretty simple. Thanks again, Richard




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco Model 38-7: what caps & resistors do fail typically?
Hello Martin, Welcome aboard our little community what great Model 38-7 Sincerely Richardradiorich — 12:30 AM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum Martin. I count about 9 paper caps, the 3 electrolytic caps and 2-Y2 safety caps to replace th...RodB — 09:44 PM
Part numbers to model cross
Jim, We have this index put together by Dale Cook but I don't think that is quite what you are looking for. The Parts...klondike98 — 09:37 PM
Philco Model 38-7: what caps & resistors do fail typically?
Yep the dim bulb test is OK but I'd definitely replace all those electrolytics before I did it. Since those #47 conden...klondike98 — 09:18 PM
Philco 42-345 Restoration/Repair
The resistor is a 2.2 Meg, it was the last one I hadn't replaced. The broadcast is coming in after replacing it.osanders0311 — 09:09 PM
Philco 42-345 Restoration/Repair
What does the resistor measure? I think it should be 3.3 Meg. If the oscillator coil has continuity and the resistanc...RodB — 09:03 PM
Philco Model 38-7: what caps & resistors do fail typically?
Good idea to check the coils... then I'll get hold of an incadescent light bulb and see what happens when the unit is sw...Musaeum — 08:49 PM
Philco 42-345 Restoration/Repair
I have that same set, ain't too much shortwave I like anyway.....it is a good AM DX set. PaulPaul Philco322 — 08:32 PM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum, Martin! Open a new thread in Philco Electronic Restoration when you begin working on your 38-7. ...GarySP — 08:28 PM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum! :wave: Here's the schematic for that radio from our digital library: Something to do bef...klondike98 — 08:05 PM

[-]
Who's Online
There are currently no members online.

>