Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 87 Help Needed
#1

Hi, I just got a Philco 87 at the local thrift store and I'm going to start and restore it. It looks to be all original minus a few parts.(still has most globe style tubes). It's missing the three smaller knobs (tuning knob is there). Can they be found? About half the dial is worn. Anyone knows if it can be restored? Also the decretive work in the speaker opening, was that on all modle 87's? I saw on a philco site one had a tapestry print. Is that also correct? Any and all help would be appreciated. thanks, Richard
------------------
Richard
#2

Hi Richard

Yes, knobs and reproduction dial scales are readily available; sources for these may be found on this site's Parts Sources page:
http://www.philcoradio.com/resource.htm

Earlier Model 87 lowboys have the decorative cutouts in the speaker grill, and plain gold cloth identical to that used in Model 20. Later 87 lowboys use the "tapestry" cloth, with no grille cutouts.

Reproduction cloth may be found at http://www.grillecloth.com .

--
Ron Ramirez
Ferdinand IN
#3

Thanks Ron, I ordered the speaker cover print and started looking for the other parts. This is the oldest one yet I have restored. Electronics pretty simple. Thanks again, Richard




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM
Hickok AC51 tube tester
Note that no power cord, power switch, or power transformer switch are shown. That (along with my experience with full s...DaleHCook — 07:09 AM
IF can wire size and Rubber mounts?
A pair of wire strippers can give you an idea of what the existing gauge of the wire leads are in the IF can, I think it...Arran — 06:07 AM
My last cabinet for this year
Hello Dan, That is really beautiful what great looking radio you have ! I have friends who live in Calgary and the wea...radiorich — 01:51 AM

[-]
Who's Online
There are currently 5547 online users. [Complete List]
» 2 Member(s) | 5545 Guest(s)
AvatarAvatar

>