New YouTube Series..1965 Silvertone R2R Model 4236
Posts: 360
Threads: 60
Joined: Jan 2013
City: Portland, Oregon
have a new series on a 1965 Silvertone Tape Recorder Model 4236
link below if anyone interested..
https://www.youtube.com/watch?v=OMZG6kpi-8M
(This post was last modified: 07-15-2016, 09:31 PM by Buzz.)
Posts: 2,572
Threads: 337
Joined: Jun 2013
City: lawrenceville nj
great change up from radios 
Some day, and that day may never come, I will call upon you to do a service for me. But until that day, accept this justice as a gift
mafiamen2
Posts: 3,135
Threads: 54
Joined: Apr 2011
City: Lexington, KY
John KK4ZLF
Lexington, KY
"illegitimis non carborundum"
Posts: 360
Threads: 60
Joined: Jan 2013
City: Portland, Oregon
Part 2 now uploaded
link below for anyone interested.
https://www.youtube.com/watch?v=RmLu5VlU2i0
Posts: 3,135
Threads: 54
Joined: Apr 2011
City: Lexington, KY
The super glue method works better with larger diameter belts. Mark Oppat sells belt material for Zeniths that work very well using fresh super glue to bond them.
Great videos Buzz, keep up the good work
John KK4ZLF
Lexington, KY
"illegitimis non carborundum"
Posts: 360
Threads: 60
Joined: Jan 2013
City: Portland, Oregon
Part 3 now uploaded
link below if interested
https://www.youtube.com/watch?v=mVf26lcH6Nc
Posts: 667
Threads: 11
Joined: Sep 2014
City: Bellmawr, NJ
Very Nice JOB,,,Again,,,,Buzz
Posts: 360
Threads: 60
Joined: Jan 2013
City: Portland, Oregon
(07-30-2016, 07:21 PM)Kenneth F. Besso Jr. Wrote: Very Nice JOB,,,Again,,,,Buzz
thank you sir 
Posts: 360
Threads: 60
Joined: Jan 2013
City: Portland, Oregon
(07-16-2016, 01:59 PM)sam Wrote: great change up from radios
 thanx
Posts: 2,572
Threads: 337
Joined: Jun 2013
City: lawrenceville nj
buzz
sounds great
poor dickel 
sam
Some day, and that day may never come, I will call upon you to do a service for me. But until that day, accept this justice as a gift
mafiamen2
Posts: 360
Threads: 60
Joined: Jan 2013
City: Portland, Oregon
Hello
Part 4 now uploaded
link below for anyone interested.
https://www.youtube.com/watch?v=iKs6hjrKkYA
Posts: 360
Threads: 60
Joined: Jan 2013
City: Portland, Oregon
Posts: 3,135
Threads: 54
Joined: Apr 2011
City: Lexington, KY
Good info as always! Thanks for taking the time to do the videos
John KK4ZLF
Lexington, KY
"illegitimis non carborundum"
Posts: 360
Threads: 60
Joined: Jan 2013
City: Portland, Oregon
(08-10-2016, 11:20 AM)Eliot Ness Wrote: Good info as always! Thanks for taking the time to do the videos
thanks Eliot...delighted you enjoy them...................Buzz
Posts: 360
Threads: 60
Joined: Jan 2013
City: Portland, Oregon
Hello 
Part 5 now uploaded
link below to anyone interested
https://www.youtube.com/watch?v=_AD_hFbdxJA
Users browsing this thread: 1 Guest(s)
|
|
Recent Posts
|
|
Philco 46-420 Code 121 Reception issues
|
| Welcome Eric,
I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM |
|
Philco 46-420 Code 121 Reception issues
|
| You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM |
|
Philco 42-1008 conversion kit
|
| Interesting. I haven't seen that before.klondike98 — 07:02 PM |
|
12' Philco
|
| Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM |
|
Shadow Meter Bulb
|
| Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM |
|
Shadow Meter Bulb
|
| Ok. Thanks for the correction.RossH — 03:09 PM |
|
Model 28L
|
| For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM |
|
37-60 revision 6
|
| I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM |
|
Shadow Meter Bulb
|
| Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM |
|
Hickok AC51 tube tester
|
| Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM |
|
Who's Online
|
| There are currently no members online. |
|
 
|
![[-]](https://philcoradio.com/phorum/images/bootbb/collapse.png "[-]")