Posts: 7,283
Threads: 268
Joined: Dec 2009
City: Roslyn Pa
Screws or tabs???
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!
Terry
Posts: 18
Threads: 8
Joined: Aug 2016
City: Copan, OK
Posts: 7,283
Threads: 268
Joined: Dec 2009
City: Roslyn Pa
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!
Terry
Posts: 2,572
Threads: 337
Joined: Jun 2013
City: lawrenceville nj
terry
I had good luck with a fada 80 door that used what looks like screws like these. but smaller brass ones
used angled sharp pick. pulled straight up on sides little at a time
then used pliers and twist out
taped ever so gentle with plastic faced hammer luck maybe
Some day, and that day may never come, I will call upon you to do a service for me. But until that day, accept this justice as a gift
mafiamen2