Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Could these tubes be the originals?
#1

I have a Philco 66 on the bench. While testing the tubes, I noticed that ALL were branded PHILCO and had similar appearance and date codes. I had no luck on finding information on the web for early Philco tubes. This radio had had some servicing (volume control, line bypass cap) but was otherwise all original.

I was wondering if the tubes were the originals as shipped? All the codes are arranged vertically, with a LETTER and a NUMBER. The codes I found were (first figure on TOP) 78: 5C, 6A7: H5, 75: C5, 42: B4, 80: B4. Looks like a month (letter) and year (number) - but just guessing.

Does anyone have a reference on-line? I do NOT have Lud's book.

Thanks,
Dave
#2

The number is the last digit of the year. Letters are months: C is January, B is October and H is February. After September 1935 the month codes changed: B is February, C is March, H is August.

In either case it seems odd to have dates so far apart (I'm quite sure Philco did not stockpile tubes for months).

These are Sylvania codes, and it's possible Philco bought tubes from someone else, which would have different codes.
#3

Is this information in the book Tube Lore or another source? It is just curious that at least the YEAR is close to the introduction date of the radio. I would not suspect that the tubes would have been changed so soon. And they are all branded Philco.

Thanks!




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Cannot Adjust an IF Transformer’s cores
Outstanding work indeed. I wish I could come up with solutions like this.slford310 — 11:16 PM
Cannot Adjust an IF Transformer’s cores
The abilities of our 'Phorum Pholks" never ceases to amaze me! Fantastic fabrication, Joseph! I'm waiting now for...GarySP — 08:27 PM
PT-6 antenna connections
Thanks. I never realized that was a notch noted in the schematic as described. I’ll recheck my wiring.bridkarl — 08:13 PM
Cannot Adjust an IF Transformer’s cores
Thank you! I was quite new to the Phorum when I started this post, so I feel like it might be advantageous to publish a ...jrblasde — 08:07 PM
PT-6 antenna connections
Notice in the schematic the notch at the bottom of the antenna coil is between pins 3 & 4. Yes, pin 6 of the 7C6 is...RodB — 07:34 PM
bridkarl
I have two PT-6 chassis. On both there is a blue wire that runs from the above chassis transformer to pin 6 of 7C6. So t...bridkarl — 07:23 PM
Cannot Adjust an IF Transformer’s cores
Joseph, now you are an engineer!!RodB — 06:37 PM
PT-6 antenna connections
Hi, reading your explanation I can see the confusion. If you take it one connection at a time it should result in a desi...RodB — 06:34 PM
Cannot Adjust an IF Transformer’s cores
It works! I received the PCBs this morning in the mail, and put everything together. I reused the base from the original...jrblasde — 04:32 PM
PT-6 antenna connections
I seem to have lost my way on this PT-6. I see the antenna aerial transformer schematic - I’m reading pins 1 through ...bridkarl — 12:30 PM

[-]
Who's Online
There are currently 4124 online users. [Complete List]
» 1 Member(s) | 4123 Guest(s)
Avatar

>